. MAINTENANCE MAINTENANCE PROCEDURE CLEAN AND INSPECT RADIATOR FINS, OIL COOLER FINS, AFTERCOOLER FINS, FUEL COOLER FINS, AND AIR CONDITIONER CONDENSER FINS (only machines equipped with air conditioner) WARNING an air conditioner, clean the the fan in reverse, see ± 0.4 lbft) 4 - 53 If compressed air, high-pressure water, or steam hits your body directly or dirt is sen t flying by the com pressed air, high-pressure wate r, or steam, there is danger of per sonal injury. Always wear protective glasses, dust mask, and o ther protective equipment. NOTICE a distance to prevent damage to the fins.
Whe n using compressed air, use from a distance to prevent damage to the fin In particular, with the fuel cooler and a ftercooler, blow with compressed air at an an gle of 45° with th e nozzle at a distance of at least 300 mm (11.8 in). Neve r blow the compressed air at right angles to the core. If the fins are damaged, i t may cause cool ant leakage or overheating. O n dusty jobsites, check the fins daily , irrespective of the maintenance interva l. 1. Open the cover (1). 2. Open duct (2) at the machine' Duct (2) opens when ten bolts 3. Use compressed to blow off m r f f " adiator fins, oil cooler fins, fue ins (3). At the same time, clea On machines equipped with condenser fins (4) also.
Steam or water can be used in Steam or water can be used in an can be rotated in reverse t of the method for rotatin MONITORING SYSTEM (PA 4. Check the rubber hose. Repla f ound to have cracks or to be Also, check hose clamps for lo Aftercooler hose clamp tighten 9.81 ± 0.49 Nm (1.0 ± 0.05 kg