. MAINTENANCE MAINTENANCE PROCEDURE METHOD OF RELEASING PRESSURE IN HYDRAULIC CIRCUIT WARNING work stroke 4 - 77 The hydraulic s ystem is always under inter nal pressure, so wh en inspecting or replacing the pipi ng or hoses, always release the pressure in personal injury. the circuit before starting. If the pressure is no t released, high pressure oil may s purt out and cause serious The parts and oi l are at high temperature a fter the engine is sto pped, and may cause serious burn s. Wait for the temperature to go down befo re starting the operation. When the oil fill er cap is removed, oil may spurt out, so turn th e cap slowly to release the pressur e before removing the cap. 1.
Stop the ma chine on firm horizonta l ground, lower th equipment to then stop the Set the loc the ground as shown in the diagram on t engine. k lever at the FREE position (F). h work equipment control lever to the ful econds after stopping the engine. starting switch at the ON position. k lever at the FREE po 2. Operate eac h work equipment contr within 5 - 6 s Leave the econds after stopping th starting switch at the O 3. Remove the cap of the hydraulic tan k. econds, then stop the engine again. n 1000 rpm. vers to the HOLD position. 4. Start the eng ine, run for approx. 10 s econds, then sto Do not run Set the wo the engine at more tha n 1000 rpm.
rk equipment control le vers to the HOLD 5. Operate eac h work equipment contr ol lever to the full stroke within 5 - 6 seconds afte Repeat St eps 4 - 5 three times. CHECK ALTER Contact your Ko matsu distributor to have the alternator ch If the engine is s tarted frequently, have t his inspection car CHECK ENGINE VALVE CLEARANCE, ADJUST Special tools are needed for inspection a nd maintenance, so contact your Komatsu distri CHECK ALL TIGHTENING POINTS OF ENGINE EXHAUST PIPE CLAMPS Please ask your Komatsu distributor to c heck the tighteni ng of the clamps between the a ir cleaner - turbocharger - aftercooler - en gine.