Komatsu — HANDLING COUNTERWEIGHT REMOVER

. ATTACHMENTS AND OPTIONS ATTACHMENT GUIDE ATTACHMENTS AND OPTIONS ATTACHMENT GUIDE (3) in the pump room to LOCK (c) REMARK prevent it from falling over before removing pins (18). 6 - 12 8. position and start up t On that occasion, if lock s witches (2) and (3) are in FRE E position (d), the engine does not s 9. After starting up the e ngine, release the warming-up mode and keep the engine runni ng at a low speed (low idling) 10. Operate counterweig ht removal / installation B co ntrol lever (12) slowly to the RAI SE (f) position and extend B re mover link cylinder (13) to the str oke end (max.). Then B remov er link (14) is stretched, and the stretched.

In this pro counterweight begins to rise a cess, raise the counterweight s it is also slowly by keeping counterweig (12) at its half stroke i ht removal / installation B co nstead of at the full stroke to ntrol lever control the rising speed. 11. Operate counterweig ht removal / installation A co ntrol lever (15) slowly to the LO WER (f) position, allowing A re mover link (16) to be stretched. At that time, the counterweigh t begins to lower together as it is also stretched. In this process , lower the counterweight slowly by keeping counterweight removal / installation A control le ver (15) at its half stroke inste ad of at the full stroke to control th e lowering speed. 12.

Lower the counterwei ght completely to the ground. 13. Remove 2 pin stopper bolts (17), then remove 2 pin s (18) from the counterweight hol es. When doing this, b e careful not to let the counte rweight fall anger of it falling over, take