. OPERATION LONG-TERM STORAGE LONG-TERM STORAGE DURING STORAGE WARNING AFTER STORAGE 3 - 152 BEFORE STORAGE re than one month), store as follows. When keeping in long-term storage (mo Clean and wash all parts, then store t he machine indoors. If the machine has to be stored outdoors, s elect level ground and cover the machine with a sheet. vents moisture from collecting. torage. aulic cylinder piston rod with grease. Completely fill the fuel tank. This pre Lubricate and change the oil before s Coat the exposed portion of the hydr Disconnect the negative terminals of t he battery and cover it or remove it from the machine and s tore it s eparately.
Set the work equipment lock lever to the LOCK position to prevent the machine from moving. To prevent corrosion, be sure to fill the cooling system with Supercoolant (AF-NAC) or permane nt type antifreeze (density between 30% and 68%). If it is necessary to perform the rust-preventi on operation while the machine is indoors, open the doors and windows to improve ventilation and prevent gas poisoning. During storage, operate and move the machine for a short distance once a month so that a new film of oil will coat moving parts. At the same time, also charge the battery. wipe off all the grease from the hydraulic cylinder rods.
When operating the work equipment, If the machine is equipped with an air conditioner, operate the air conditioner for 3 to 5 minute s once a month to lubricateall parts of the air conditioner check the refrigerant level twice a ye compressor. Always run the engine at low idle when doin g this. I n addition, ar. NOTICE If the machine has been stored without carr ying out the monthly rust-prevention operation, consult your K omatsu distributor before using it. When using the machine after long-term storage, do as follows before using it. c cylinder rods. oints.
Wipe off the grease from the hydrauli Add oil and grease at all lubrication p When the machine is stored for a long period, moisture in the air will mix with the oil. Check the o il befor e and after starting the engine. If there is water i n the oil, change all the oil. gine pulley and no abnormality in the belt. ontact surface of the pulley, remove it with a wire brush. sion to ensure that there is no slipping. justing the belt tension, see CHECK ALTERNATOR BELT TENSION, Check that there is no rust on the en If there is excessive rust on the belt c ontact surface of the pulley, remove it with a wire brush.
If the belt is loose, adjust the belt ten (For details of the procedure for ad ADJUST (PAGE 4-47).)