Komatsu — WHEN MACHINE RUNS OUT OF FUEL

. OPERATION TROUBLESHOOTING TROUBLESHOOTING PROCEDURE FOR BLEEDING AIR CAUTION 1. Loosen air bleed plug (A), (B) at the fuel filter head (1). Tightening torque: 4.9 to 6.9 Nm (0.5 to 0.7 kgm , 3.6 to 5.1 lbft) 3 - 153 WHEN MACHINE RUNS OUT O F FUEL When startin g the engine again after ru nning out of fuel, fill with fuel, then bleed the air f rom the fuel system before startin g the e ngine. eful not to run out of fuel. Alway s watc h the fuel level and be car eful not to run out of fuel I f the engine has stopped because of la ck of fuel, it is necessary to use the priming pump to bleed the air completely from t he fuel circuit.

Thi s engine consists of higher precision parts than on the conventional fuel injection pump and nozzle, so if dirt gets in, it will cau se problems. If there is any dirt stuck to the fuel line, use fuel to wash it off completely. Be careful w hen opening the air bleed p lug at the fuel filter head and the air bleeder of the su pply pump. The system is still und er pressure and fuel may spurt out. 2. L oosen t he knob of priming pump ( 2), then pump the knob until no more bubbles co me out of air bleed plug (A). 3. W rap sealing tape around air bleed it. Ti ghtening torque: 2.0 to 3.9 Nm (0. 4. O perate the priming pump again b ubbles c ome out with the fuel fro 5.

Ti ghten a ir bleed plug (B). ghtening torque: 4.9 to 6.9 Nm (0. 6. L oosen a ir bleeder (4) of the suppl 7. P ump priming pump (3) (approx. 90 ubbles c r bleed ome out with the fuel from er (4).