Komatsu — METHOD OF TOWING MACHINE

. OPERATION TROUBLESHOOTING METHOD OF TOWING MACHINE WARNING 3 - 154 8. Continue pumping (approx. 50 times) until th sound becomes continuous. e priming pump (3) becomes stiff and the overflow valve release hten it. RT position and start the engine. 9. Push the knob of priming pump (3) in and tig 10. Turn the key in the starting switch to the STA When doing this, do not crank the starting mot start, wait for at least 2 minutes, then try agai or continuously for more than 20 seconds. If the engine does not n. Perform this operation a maximum of 4 times. ion from Step 1. 11.

If the engine does not start, repeat the operat Serious injury or death could result if there is any mista of wire rope or method of towing a disabled machine. Always be sure to check carefully that the capacity of for towing is ample for the weight of the towed mach Never use a wire rope which has cut strands (A), red or kinks (C). There is danger that the rope may break operation. Always wear leather gloves when handling wire rope Never tow a machine on a slope. During the towing operation, never stand between th and the machine being towed. Move the machine slowly and be sure not to apply a the wire rope.

If there is a failure in the brake line, the brakes cann extremely careful when towing. NOTICE Only tow the machine for a short distances, such as The machine must not be towed for long distances. For details of the permissible towing load for this m For details of the procedure for towing a machine w This machine must not be towed except in emerg encies. When towing the machine, take the following precautions. Before releasing the brakes, put blocks under t he wheels to prevent the machine from moving. If the wheels are not blocked, the machine may suddenly move.

When towing a machine, tow it at a low speed of less than 2 km/h (1.2 MPH), and for a distance of a few meters to a place where repairs can be carried out. Th e machine should be towed only in emergencies. If the machine must be moved long distances, use a transpor ter. If it is impossible to operate the steering and b rakes of the machine being towed, do not let anyone ride on the machine. Keep the angle of the towrope as small as possi ble. Keep the angle between the centerlines of the two machines to within 30 degrees. The towing machine should normally be of the same class as the machine being towed.

Check that the towing machine and towed machine both have ample braking power and that the towing machine has ample rimpu ll to control both machines on the slopes or on the tow road. cessary to connect another machine to the rear of the machine When towing a machine downhill, it may be ne being towed in order to provide ample rimpull a nd braking power. This makes it possible to prevent the machine from losing control.