. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE 4 - 24 4. Set a container in position t o catch the drained antifreeze (3) under the left side of the fuel side face of the cylinder block, se drain valve (3) and drain plug the engine, and run it at low idle. ow idle for 10 minutes until the more than 90°C (194°F). alve (3) and drain plug (4), drain gain. the cooling system with cleaning agent. the instructions for the cleaning agent. r, then open 2 valves (1). or replacing the corrosion resistor, see "REPLACE CORROSION RESISTOR eze until it overflows from the water filler. mixture, then open drain valve tank and drain plug (4) at the and drain the coolant. 5.
After draining the coolant, clo (4) and fill with city water. 6. When the radiator is full, start Keep the engine running at l coolant temperature reaches 7. Stop the engine, open drain v the water, then tighten them a 8. After draining the water, clean the cooling system with cleanin For the cleaning method, see the instructions for the cleaning 9. Replace the corrosion resisto For details of the procedure f CARTRIDGE (PAGE 4-57)". 10. Add coolant mixed with antifre eze until it overflows from the Decide the proportions of antif reeze and water according to the table for the mixing rate of water and antifreeze. 11.
To bleed the air from the cooli ng system, run the engine at low idle for 5 minutes, and for a further 5 minutes at high idle. (When doing this, le 12. Drain the coolant from sub-t sub-tank, then add water until FULL and LOW marks. 13. Stop the engine, wait for appr until the coolant level is near t the cap. Check the coolant le