. MAINTENANCE SERVICE PROCEDURE CHECK WATER SEPARATOR, DRAIN WATER WARNING The water separator separates the water from the fuel. 1. Open the engine side cover on the right side of the chassis. 2. Open cover (1). The water separator forms one unit with the additional fuel filter and is at the bottom. is 4 - 25 Each part of the engine is still highly heated immediatel y after the e ngine is s topped. Do not attempt to dr ain cooling water or remove th e filter element cup. High pres sure is generated inside th e engine fuel pipin g, whil e the engine is running. Wait for more than 3 0 seconds after the engine st op for the e ngine to sufficie ntly cool down.
Th en star t wit h draining cooling water or removing th e filter element cup. Do not bri ng fire close. This engi ne consists of higher preci sion parts than on t he conventional fuel i njection pump and nozzle, so if dirt gets in, it will cause pro blems. If t here is any dirt stuck to the fuel lin e, use fuel t o wash it 3. Loosen plug (2) and drain the 4. It is po ssible to ndition of water and s through accum dischar ). If water or sediment ulated, se t a container u nder drain hose (4 ) to collect ged wate 5. Tighten plug (2) drain h (Tighte ning torque: 0.2 - 0.45 Nm {0.02 - 0.046 kgm})