. MAINTENANCE SERVICE PROCEDURE CLEAN FINS WITH COMPRESSED AIR Tilt aftercooler (1) at the top front face of the radiator, swing oil cooler (2) at the bottom, then insert the steam jet nozzle through the gap and clean the fins. Turn the knob (4) counterclockwise to release the lock, then swing oil cooler (2). If necessary, band (5) can be fitted to oil cooler (2) to hold it in position after swinging it. 3. Use the steam jet nozzle to blow out the mud, dirt, or leaves clogging the radiator fins or cooler fins. 4 - 32 METHOD OF TILTING AND SWI 1. Turn the starting switch to the OFF position and stop the engine. 2.
Pull lever (3) down to relea NOTICE If the steam jet nozzle is brought to o close to the radiator fins, it may damage the fins, so keep the n ozzle a suitable distance away from the fins when cleaning. 4. Check the rubber hose. Replace with a new one if the hose is found to have cracks or to be hardened by aging Also, check hose clamps for looseness. 5. Do as follows to blow out the mud or dirt that has fallen to the bottom. 6. Loosen wing bolts (6), use hook (7) to slide cleaning covers (8), and open the left and right covers. 7. Insert the air nozzle and blow the dirt out to the front of the machine. REMARK Steam or water can be used instead of compressed air. 8.
After blowing out the dirt, install left and right cleaning covers (8). 9. After completing the cleaning, push the bottom of aftercooler (1) to lock it, then push the front of oil cooler (2) to lock it. Check that they are both securely locked in position. 4. Check the rubber hose. Re place with a new one if the hose is found to have cracks or to be hardened by a ging 9. After completing the cleani ng, push the bottom of aftercooler (1) to l ock it, then push the front of oil cooler (2) to ecurely locked in position.