. MAINTENANCE SERVICE PROCEDURE CHANGE OIL IN ENGINE OIL PAN, REPLACE ENGINE OIL FILTER CARTRIDGE WARNING may cause burns. Wait for the 4 - 52 EVERY 500 HOURS SER Maintenance for every 50, 100 and 250 hours service should be carried out at the sa The parts and oil are at high t emperature immediately after the engine is stopped, and starting the work. temperature to go down before When removing the oil filler cap, turn it slowly to release the internal p ressure, then remove Refill capacity: 38 liters (10.0 Prepare a filter wrench 1. 2. 3. Open the engine side cove Open oil filler (F). Place a container to catch t r on the right side of the chassis. he oil under drain plug (P). 4. 5.
Loosen drain plug (P), and Check the drained oil, a particles or foreign materi distributor. Install drain plug (P). drain the oil. nd if there are excessive meta al, please contact your Komatsu 6. 7. 8. Using a filter wrench, turn fi on remove it. Clean the filter holder, fill th lter cartridge (1) counterclockwise e new filter cartridge with oil, then 9. coat the seal and thread of thinly with grease) and inst When installing, bring the the filter cartridge with oil (or coa all. seal surface into contact with the urther 3/4 to 1 turns. filter holder, then tighten a f 10.
After replacing the filter car tridge, add oil through oil filler (F until the oil level is between the H and L marks on the dipstick (G). 11. Run the engine at idle for sh ort time, then stop the engine, and check that the oil is between the H and L marks on the dipstick For details, see "CHECK O ADD OIL (PAGE 3-95)". IL LEVEL IN ENGINE OIL PAN