. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE NOTICE 4 - 54 When adding fuel, do not remove cap (B). Always add fuel f rom the 8 small holes (A) on the dirty side. ove cap (B) and install the fuel filter. After a dding fuel, rem ove cap (B) and install Alway s fill with clean fuel. Be careful not to let any dirt or du st get into the fu el. In particular, center portion is the cl ean side, so do n ot remove cap (B ) when adding f uel. Be careful not to le t dirt or dust get i nto center portio n on the clean s 7. Whe n installing, ti ghten until the packi ng surface cont acts the seal s urface of the filter h older, t hen tighten i t 3/4 of a turn.
If th e filter cartridg e is tightened too fa r, the packing will be damage d and this wi ll lead t o leakage of f uel. I f the filter cartridge is to o loose, fuel will als o leak from the packing , so a lways tighte n the co rrect a mount. W hen tightenin g with a filter wrench , be extremely careful n ot to dent o r damage the 8. Afte r completion o f the replacement o f fuel filter cartr idge (1), bleed the a Blee d the air as fo 9. Add fuel to the fue l tank until full (to F ULL mark on th e fuel gauge). 10. Afte r replacing filt er cartridge (1), loos en air bleed plu g (3) and add fuel u ntil no more b ubbles come out i n the fuel from the air bl 11.
Afte r replacing the filter cartridge, start the engine an d check f or any leakage of f uel from the fi lter sea l surface.