Komatsu — EVERY 1000 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE REPLACE FUEL FILTER CARTRIDGE WARNING Prepare a filter wrench and a container to catch the fuel. 1. Set the container to catch the fuel under the filter cartridge. 2. Using a filter wrench, turn filter cartridge (1) counterclockwise on remove it. 3. Clean the filter holder. NOTICE Do not fill the filter cartridge with fuel. Cap (A) is installed to prevent dirt from entering the inside of the filter cartridge. A 4. Coat the packing surface of the filter cartridge with oil. 9 J A 0 7 6 3 9 4 - 58 After the en gine has been operated, all parts are at high temperature, so do not replace t he filter immediately.

Wait for all parts to cool dow n before starting the operation. nning. High press ure is generated inside the engine fuel piping system when the engine is ru When repla replacing t cing the filter, wait for at least 30 seconds after stopping the engine to let the internal pressure go down before he filter. g any fire or flame close. Do not brin NOTICE Genuine K omatsu fuel filter cartridges use a special filter that has highly efficient filte ring ability. When replacing the filter cartridge, a lways use a genuine Komatsu part. The comm on rail fuel injection system used on this machine consists of more precise parts than the conventional injection pump and If any part system. Al nozzle.

other than a genuine Komatsu filter cartridge is used, dust or dirt may get in and cause problems with the injection ways avoid using substitute parts. When carry ing out inspection or maintenance of the fuel system, pay more attention th an normal to the entry of dirt. If dirt is stuck to an y part, use fuel to wash it off completely. 5. Remove filter cartridge cap (A) and install to the filter holder. 6. When in stalling, tighten until the packing surface contacts the seal surface of the filter holder, then tighten it 3/4 of a turn If the filt filter cart . er cartridge is tightened too far, the packing will be damaged and thi s will lead to leakage of fuel.

If the ridge is too loose, fuel will also leak from the packing, so always tig hten the correct amount.