Komatsu — EVERY 2000 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE CLEAN PPC CIRCUIT STRAINER WARNING 5. Install rubber hose (1). CLEAN ENGINE BREATHER ELEMENT WARNING 4 - 64 After the engine is stopped, th e parts and oil are at high temperature , an d may cause burns. Wait f or the temperature to go down before starting the opera When the rubber hose is remov ed, oil may spurt out, so turn it slowly t o release the internal pressure, then remove it carefully. 1. When rubber hose (1) and flange (2) are removed, oil will sp out, so set a container (ca pacity: approx. 300 cc) in position t catch the oil. nd flange (2). ash it in clean diesel oil. er case (4) from the concave sid 2. Remove rubber hose (1) a 3.

Remove strainer (3) and w 4. Install strainer (3) in strain then install with flange (2). REMARK Assemble with the protruding side (O-ring side) of the strainer a t the fron The parts and oil are at high te mperature after the engine is stopped, and may cause serious burns. Wait for the temperature to go down before cleaning the engine breather. ere is a hazard that dirt may be blown up and cause serious injury. st mask, or other protective equipment. When using compressed air, th ere is a hazard that dirt may be blown up a nd c Always use safety glasses, du st mask, or other protective equipment 1. Wipe away dust around th e breather. 2. Loosen the clamp and rem ove the hose.

Remove breather (1 3. Clean the breather body w ith light oil or cleaning oil. 4. Replace O-ring with new o ne. Coat a new O-ring with engin oil, set it, then install breat her (1). 5. Check the breather hose a nd pipe. If caked oil (sludge) adher to insides, replace the hos e and pipe with new parts.