Front Axle 33 5. Place a turn-plate or turntable under each front tire. Remove the safety stands from under the axle, then lower the vehicle. Remove the lock- pins from the gauges; make sure the tires are exactly straight ahead. NOTE: If turn-plates or turntables are not avail- able, lower the vehicle. Remove the chocks from the rear tires and release the parking brakes. Move the vehicle backward and then forward about six feet (two meters). 6. Place a trammel bar at the rear of the front tires; locate the trammel pointers at spindle height, and adjust the pointers to line up with the scribe lines on the center ribs of the front tires. See Fig. 12 . Lock the pointers in place.
Check that the scale is set on zero. f330014a 08/30/94 Fig. 13, Trammel Bar Positioning B f330082a 08/29/94 NOTE: B minus A equals toe-in. A. Distance at front of tires. B. Distance at rear of tires. Fig. 12, Wheel Toe-In (overhead view) f400100a 08/30/94 7. Place the trammel bar at the front of the tires, see Fig. 13 , and adjust the scale end so that the pointers line up with the scribe lines. See Fig. 14 . Fig. 14, Setting Trammel Bar Pointers 8. Read the toe-in from the scale. Toe-in should be in the range of -1/32 to +3/32 inch. If corrections are needed, take the vehicle to your Western Star Dealer to adjust the toe-in. The Toe-in should be set as close as possible to +1/32 inch.
Western Star Maintenance Manual, September 2015 33/7 A