Daimler Trucks North America LLC Western Star — Western Star

Front Axle 33 to exceed 25 mph (40 km/h), to thoroughly circu- late lubricant throughout the carrier and housing assembly. on the road contact surfaces of the tread. Also, a rapid wear on the steering axle could occur usu- ally in a feathered-edge pattern. See Fig. 11 . 33–07 Wheel Alignment Check Feathered-edging more often affects the front tire on the passenger’s side of the vehicle, and is usually more apparent on the outside groves of the tire. General Information If any of these listed conditions occur, the vehicle could need a front end alignment. The axles and wheels are aligned at Western Star using Hunter laser alignment equipment.

Correct front axle alignment is needed to ensure long tire life, ease of handling, and steering stability. A 1. Camber is the vertical tilt of the wheel as viewed from the front of the vehicle. Camber angle is measured in degrees, and is not adjustable. Negative camber is the top of the wheels tilted inwards. Front tires wearing on the inboard side may be due to excessive negative camber. See Fig. 10 . A f400094a 08/29/94 A. Feathered-Edges. Fig. 11, Tire Wear Due to Excessive Toe-In Toe-In Inspection For vehicle alignment to be accurate, the shop floor must be level in every direction.

The turn plates for the front wheels must rotate freely without friction, and the alignment equipment must be calibrated every three months by a qualified technician from the equipment manufacturer. Western Star dealers must have proof of this calibration history. f400097a 08/29/94 A. One side of tread is worn excessively. Fig. 10, Tire Wear Due to Excessive Camber 2. Caster is the tilt of the knuckle pin (or king-pin), as viewed from the side. Caster angle is mea- sured in degrees and is adjustable. An incorrect caster angle does not cause tire wear. However, a positive caster angle that exceeds specifica- tions could cause vehicle shimmy and an in- creased steering effort.

Excessive negative caster angle could cause unstable steering, and the vehicle may wander and weave. 1. Apply the parking brakes and chock the rear tires. 2. Raise the front of the vehicle until the tires clear the ground. Check that the safety stands will support the combined weight of the cab, axle, and frame. Place safety stands under the axle. 3. Using spray paint or a piece of chalk, mark the entire center rib of each front tire. 3. Wheel toe-in is the distance that the front of the wheels are closer together than the rear of the wheels. Wheel toe-in is adjustable. If toe-in is not correct, the vehicle could pull to one side while driving.

Wheel shimmy and excessive tire wear could occur. The tires would display indentations 4. Place a scribe or pointed instrument against the marked center rib of each tire, and turn the tires. The scribe must be held firmly in place so that a single straight line is scribed all the way around each front tire. Western Star Maintenance Manual, September 2015 33/6