Front Axle 33 Eaton Drive Axle Recommended Lubricants Lubricant Type Conditions SAE Viscosity Eaton® Roadranger® Synthetic Drive Axle Lubricants, or Equivalent with Military Specification MIL-L-2105D Over-the-Road Service 75W-90 Off-Highway, or Under Extra-Heavy Loads 80W-140 Table 1, Eaton Drive Axle Recommended Lubricants Lubricant Type Outside Air Temperature SAE Viscosity Meritor Drive Axle Recommended Lubricants +10°F (-12°C) & Up * 85W-140 Hypoid Gear Oil API-GL-5 with Military Specification MIL-L-2105C -40°F (-40°C) & Up * 75W-90 Synthetic Gear Oil -40°F (-40°C) & Up * 75W-90 -40°F (-40°C) & Up * 75W-140 -40°F (-40°C) & Up * 75W-140 * There is no upper limit on these outside air temperatures, but axle sump temperature must never exceed 250°F (121°C).
Table 2, Meritor Drive Axle Recommended Lubricants 33–06 Front Drive Axle Lubricant Change IMPORTANT: The axle should not be flushed with any solvent, such as kerosene. 6. Clean the fill and drain plugs. A piece of keystock or other convenient steel bar may be used across the magnetic poles to divert the magnetic field. Clean the metallic particles from the plug. NOTE: The magnetic plug should have a mini- mum pickup capacity of 1-1/2 lb (0.7 kg) of low- carbon steel, in bar or plate form. Magnets will rapidly loose effectiveness as collected material bridges the gap between the two poles. Clean or change the plugs before this occurs.
It may be necessary to clean or change the plugs one or more times between lubricant change inter- vals. NOTICE Failure to change the axle lubricant at more fre- quent intervals, when adverse operating condi- tions require, could result in axle damage. Refer to Table 1 and Table 2 for recommended drive axle lubricants. 1. With the vehicle parked on level ground, apply the parking brakes and chock the tires. 2. Clean the area around the fill plug. Remove the fill plug. 7. Install and tighten the drain plug to 35 lbf·ft (47 N·m). 3. Place a drain pan under the axle. Remove the drain plug from the bottom of the housing and completely drain the lubricant, while the unit is warm. 8.
Fill the axle housing to the bottom of the fill hole, ( Fig. 9 ) using the specified lubricant. See Table 1 and Table 2 for recommended drive axle lubricants. 4. The drained oil should be stored appropriately for recycling. 5. It is necessary to flush the axle the first time (ONLY) that the axle lubricant is changed. Flush the axle with clean flushing oil, then drain it thor- oughly. The drained oil should be stored appro- priately for recycling. 9. Install and tighten the fill plug to 35 lbf·ft (47 N·m). 10. Remove the chocks. Then drive the vehicle, un- loaded, for 1 to 2 miles (2 to 3 km) at speeds not Western Star Maintenance Manual, September 2015 33/5