Front Axle 33 3 A 1 2 07/18/2001 1. Temperature Sensor Plug 2. Fill Plug 3. Drive Axle Breather f350408 07/17/2001 f330179 1. Correct Lubrication Level Fig. 7, Front Hubcap Inspection Window Fig. 8, Drive Axle Housing 33–05 Front Drive Axle Lubricant Level Check 4. Lubricant should be level with the bottom of the fill hole. See Fig. 9 . If low, check the axle for leaks, and have any leaks corrected. Add lubri- cant as required. See Table 1 and Table 2 for recommended drive axle lubricants. NOTICE Failure to keep drive axle lubricant filled to the proper level with the recommended axle lubricant can result in axle damage. A NOTE:
Follow the recommended maintenance schedule for draining and flushing the drive axles. See Group 00 for time or mileage inter- vals. B 1. With the vehicle parked on level ground, apply the parking brakes and chock the tires. 08/17/2009 f350061a 2. If the vehicle has just been driven, allow a few minutes for the lubricant to settle. A. Correct (lubricant level at bottom of fill hole) B. Wrong (lubricant level below fill hole) 3. Clean the oil fill plug and the area surrounding it. Remove the fill plug. See Fig. 8 . Fig. 9, Drive Axle Lubrication Level 5. Apply a small amount of thread sealant (Loctite® or equivalent), to the threads of the filler plug.
Install and tighten the fill plug 40 to 60 lbf·ft (54 to 81 N·m). NOTE: A lubricant level close enough to be seen or touched is not sufficient. It must be level with the bottom of the fill hole. Western Star Maintenance Manual, September 2015 33/4