Front Axle 33 sitions. If the cross tube does not rotate in either direction, replace both tie rod ends. rod ends are threaded in the cross tube past the clamps and the slots at the cross tube ends. 4. Position yourself directly below the ball stud socket. Using both hands, grab the end as close to the socket as possible, no more than 6 inches (15.2 cm) from the end. Firmly apply about 100 pounds of hand pressure in an up and down mo- tion several times. When moving the assembly, check for any movement at both tie rod ends. See Fig. 6 . 8. Check the zerk fittings for damage. If a zerk fit- ting is damaged, replace it. Some tie rod ends have no zerk fittings because they are not greaseable.
Do not install a zerk fitting on a nongreaseable tie rod end. 9. Check that the cotter pin is in place. If it is not, tighten the tie rod end nut to one of the following specs depending on the axle manufacturer. If any movement is detected at one tie rod end, replace both tie rod ends. Always replace tie rod ends in pairs, even if only one tie rod end is damaged. For Detroit axles, tighten the castle nut to 120 to 170 lbf·ft (163 to 230 N·m). To align the cotter pin hole with the castle nut slot, turn the nut up to 1/6 turn (maximum). For Meritor axles, tighten the tie rod end nut per the size of the stud:
7/8–14, 160 to 300 lbf·ft (217 to 406 N·m) 1–14, 250 to 450 lbf·ft (339 to 610 N·m) 1-1/8–12, 350 to 650 lbf·ft (475 to 881 N·m) 1-1/4–12, 500 to 675 lbf·ft (678 to 915 N·m) 10. Check the steering arm bolts for a minimum torque of 300 lbf·ft (406 N·m). If the steering arm bolt torque has fallen below this specification, remove the bolt, clean all the threads, and apply new Loctite® 680. Tighten the bolt 300 to 450 lbf·ft (406 to 610 N·m). 10/10/2001 f330195 Fig. 6, Check Movement of Tie Rod End NOTICE 33–04 Front Axle Wheel Bearing Lubrication Do not attempt to straighten a bent cross tube. Doing so could result in damage to the axle.
Be sure to replace the cross tube with an original equipment cross tube with the same length, diam- eter, and thread size as the existing cross tube. Stemco front axle hub caps have a transparent in- spection window with lubrication level marks for checking the amount of lubricant available for the front wheel bearings. See Fig. 7 . If the lubricant level is low, remove the center fill plug and add lubricant until the level reaches the mark. Fill the hub with Hypoid Gear Oil API-GL-5 with Military Specification MIL-L-2105C, SAE viscosity 75W-90. 5. Check the cross tube for cracks or other dam- age. If the cross tube is bent or damaged, re- place the cross tube. 6. Check the clamps for damage.
If a clamp is damaged, replace the clamp. Replace the entire cross tube assembly if either clamp is welded to the cross tube. 7. Check for proper installation of the tie rod end clamp to the cross tube. Make sure that the tie Western Star Maintenance Manual, September 2015 33/3