Front Axle 33 1 1 A 11/21/95 f330129 A. Grease exits 1. Grease Fitting 09/06/96 f320032a 1 grease, NLGI Grade 2 (8% 12-hydroxy lithium stear- ate grease), until new grease is seen at the bushing grease seal opposite the fittings. The grease seal will accept grease pressure without damage, and is de- signed to have grease pumped out through it during lubrication. Even if grease leaks out around the top, or bottom-plate gasket, continue pumping until new grease is seen at the bushing seal opposite the grease fitting; see Fig. 4 . Fig. 3, Dana Spicer Knuckle Pin Lubrication A. Grease exits 1. Grease Fitting Fig. 4, Knuckle Pin Lubrication, Meritor Axles 2 NOTE:
For operation in very cold climates, use NLGI Grade 1 (6% 12-hydroxy lithium stearate grease). 33–02 Tie Rod Lubrication 06/12/2012 f330273 1 NOTE: Some axles require lubrication of the tie rod ends. NOTE: No grease should emit from the tie-rod boot. If grease emits from the tie-rod boot, the boot is dam- aged. 1. Wipe the tie rod end grease fittings clean. 1. Grease Fitting 2. Boot 2. Pump multipurpose chassis grease, NLGI Grade 1 (6% 12-hydroxy lithium stearate grease) or NLGI Grade 2 (8% 12-hydroxy lithium stearate grease), into the tie rod ends until all used grease is forced out and fresh grease is seen at the ball stud neck. See Fig. 5 . Fig.
5, Grease Fitting and Boot (Detroit axle shown) 1. Shut off the engine, apply the brakes, and chock the rear tires. 2. Check the tie rod boot for cracks, tears, or other damage. If the tie rod boot is damaged, replace the entire tie rod end. 33–03 Tie Rod Inspection 3. Grasp by hand (or use a pipe wrench with jaw protectors to avoid gouging the cross tube) and slightly rotate the cross tube toward the front of the vehicle and then slightly toward the rear. Then center the cross tube between the stop po- IMPORTANT: If the tie rod end boot is torn or missing, replace the entire tie rod end. Do not replace the boot only. Western Star Maintenance Manual, September 2015 33/2 A 1