Daimler Trucks North America LLC Western Star — Western Star

Front Axle 33 Safety Precautions DANGER 1 When working on the vehicle, shut down the en- gine, set the parking brake, and chock the tires. Before working under the vehicle, always place jack stands under the frame rails to ensure the vehicle can not drop. Failure to follow these steps could result in serious personal injury or death. 33–01 Knuckle Pin Lubrication A NOTICE Use regulated pressure when lubricating the knuckle assemblies, otherwise damage could re- sult to the knuckle caps. Detroit Axles 1. Park the vehicle on a level surface, shut down the engine, and set the parking brake. Chock the tires. When lubricating upper and lower knuckle assemblies, do not raise the front axle. B 1 2.

Wipe the fittings clean. 06/07/2012 f330272 A Upper View, LH Side B Lower View, LH Side 1. Grease Fitting 3. Apply multipurpose chassis grease, NLGI Grade 1 (6% 12-hydroxy lithium stearate grease) or NLGI Grade 2 (8% 12-hydroxy lithium stearate grease), until new grease is seen at the junctions of the axle beam and knuckles. For locations of grease fittings, see Fig. 1 ; for grease exit points, see Fig. 2 . Fig. 1, Grease Fittings, Detroit Axles Dana Spicer Axles Park the vehicle on a level surface, apply the parking brakes, and chock the tires. When lubricating upper and lower knuckle assemblies, do not raise the front axle.

Wipe the fittings clean, then apply multipurpose chassis grease, NLGI Grade 1 (6% 12-hydroxy lithium stearate grease) or NLGI Grade 2 (8% 12- hydroxy lithium stearate grease), until new grease is seen at the junctions of the axle beam and knuckles. See Fig. 3 . Knuckle pins without grease fittings are permanently lubricated. Meritor Axles 09/13/2012 f330275 Fig. 2, Knuckle Pin Grease Exit Points, Detroit Axles Park the vehicle on a level surface, apply the parking brakes, and chock the tires. When lubricating knuckle pin bushings, do not raise the front axle. Wipe the lube fittings clean, and apply multipurpose chassis Western Star Maintenance Manual, September 2015 33/1