Daimler Trucks North America LLC Western Star — Western Star

Rear Axle 35 Safety Precautions DANGER When working on the vehicle, shut down the en- gine, set the parking brake, and chock the tires. Before working under the vehicle, always place jack stands under the frame rails to ensure the vehicle can not drop. Failure to follow these steps could result in serious personal injury or death. 2 35–01 Drive Axle Lubricant Level Check A NOTICE 1 Failure to keep the rear axle filled to the proper level with the recommended lubricant can result in rear axle damage. 1. Park the vehicle on a level surface, shut down the engine, and set the parking brake. Chock the tires. 2. If the vehicle has just been driven, allow a few minutes for the lubricant to settle.

2 3. Clean the oil fill hole plug (located in the carrier or the side of the axle housing) and the area sur- rounding it, then remove the plug. For Detroit axles, see Fig. 1 ; for Meritor axles, see Fig. 2 ; for Dana Spicer axles, see Fig. 3 . NOTE: Some Detroit and Meritor axles have a small tapped and plugged hole located below the housing oil fill hole. This smaller hole is for the lubricant temperature sensor only and must not be used as a fill or level hole. 4 3 B 12/07/2010 f350509a A. Front View B. Rear View 1. Axle Breather 2. Breather Hose 3. Temperature Sensor Port 4. Oil Fill Plug IMPORTANT: A lubricant level close enough to be seen or touched is not sufficient.

It must be level with the bottom of the fill hole. 4. Check the level of the lubricant. The lubricant must be level with the bottom of the oil fill hole (see Fig. 4 ). If low, check for oil leaks (and make corrections as needed), and add oil to the level of the fill plug. Fig. 1, Detroit Tandem Axle (forward axle shown) For Meritor axles, see Table 3 for approved axle lubricants, and Table 4 and Table 5 for axle ca- pacities. For Detroit axles, see Table 1 for approved axle lubricants and Table 2 for lubricant capacities. For Dana Spicer axles, see Table 6 for approved axle lubricants, and Table 7 for axle capacities. Western Star Maintenance Manual, September 2015 35/1