Rear Axle 35 4 A B 1 07/21/2011 f350539 2 3 08/17/2009 f350061a 1. Oil Fill Plug 2. Temperature Indicator Plug 3. Oil Drain Plug 4. Breather Hose A. Correct (lube level at bottom of fill hole) B. Incorrect (lube level below fill hole) Fig. 4, Axle Lubricant Level Check the possibility of dirt and road grime entering the assembly. Remove the plug, and check the oil level. If low, add fluid using the same lubricant recommended for the drive axle. Fig. 2, Plug and Breather Locations, Meritor Axles 3 Detroit Drive Axle Lubricants * IMPORTANT: Lubricant used in Detroit rear axles must meet Mercedes-Benz specification 235.20 (mineral) or 235.8 (synthetic).
Mobil Delvac Gear Oil A 80W-90 and Mobilube HD-A Plus 80W-90 meet specification 235.20. Mobil Delvac 1 Gear Oil 75W-90 and Mobilube 1 SHC 75W-90 meet specification 235.8. For more product information, see http://bevo.mercedes-benz.com. 1 Type Ambient Temperature SAE Viscosity Grade Mineral Oil (–26.1°C) and up 80W–90 Synthetic Oil (–40°C) and up 75W–90 2 * Detroit rear axles do not require the use of friction modifiers. There is no upper limit on the ambient temperature, but axle sump tem- perature must never exceed 250°F (121°C). Table 1, Detroit Drive Axle Lubricants 12/09/2010 f350531 1. Oil Fill Plug 2. Oil Drain Plug 3. Axle Breather Fig.
3, Plug and Breather Locations, Dana Spicer Axles Detroit Rear Axle Lubricant Capacity 5. Install the oil fill hole plug and tighten it per the following: Axle Oil Capacity: Quarts (liters) For Detroit axles: 30 lbf·ft (41 N·m). Forward-Rear 15.9 (15.0) * Single and Rearmost Tandem 10.6 (10.0) * For Meritor axles: 35 lbf·ft (47 N·m). * Actual oil capacity might vary slightly depending on gear ratio. Table 2, Detroit Rear Axle Lubricant Capacity For Dana Spicer axles: 50 lbf·ft (68 N·m). 6. On non-drive axles using oil-lubricated wheel bearings, clean the hub cap and plug to minimize Western Star Maintenance Manual, September 2015 35/2