Rear Axle 35 Dana Spicer Drive Axle Recommended Lubricant 35–02 Two-Speed-Axle Shift Unit Lubricant Level Check Lubricant Type Condition Lubricant SAE Viscosity Grade Dana Spicer Roadranger® Synthetic Drive Axle Lubricants, or Equivalent with Military Specification MIL–L–2105D Over-the-Road Service 75W–90 Off-Highway Equipment, or Under Extra Heavy Loads Failure to keep the two-speed-axle shift unit filled to the proper level with the recommended lubri- cant can result in shift unit damage. 80W–140 Table 6, Dana Spicer Drive Axle Recommended Lubricant 1. Clean the oil fill plug and the area surrounding it. Remove the fill plug. See Fig. 6 .
Dana Spicer Drive Axle Lubricant Capacities Axle Model Capacity * : Pints (liters) DD405 31 (14.7) DP463P 40 (18.9) 1 * Quantities listed are approximate. Fill axle until lubricant is level with bot- tom of fill hole with vehicle on level ground. Add 2 pints (1 L) of additional lubricant to the power divider. Table 7, Dana Spicer Drive Axle Lubricant Capacities NOTE: The same lubricant that is used for the drive axle lubricates the rear axle wheel bear- ings. See Fig. 5 . 2 3 f350021a 08/06/93 1. Gasket 2. Fill Plug 3. Shift Unit Housing Cover Fig. 6, Two-Speed-Axle Shift Unit A 2. Lubricant should be level with the bottom of the fill hole.
If lubricant level is low, check for leaks and have them corrected. Add lubricant as re- quired. Use the same lubricant as the drive axle. 35–03 Drive Axle Breather Check 07/18/2001 f350407 A. Lubricant level. Fig. 5, Drive Axle Wheel Bearing Lubrication Axle breathers must NOT be clogged. Whenever the axle lubricant level is checked, be sure the axle breather is also checked. If operating under adverse conditions, check the breathers more often. If the breather is damaged or plugged, have it cleaned or replaced. For the location of the breather on Detroit Western Star Maintenance Manual, September 2015 35/4 CAUTION