Daimler Trucks North America LLC Western Star — Western Star

Rear Axle 35 axles, see Fig. 1 ; for Meritor axles, see Fig. 2 ; and for Dana Spicer axles, see Fig. 3 . 4.1 For magnetic plugs, use a piece of key stock or any other convenient steel slug to short the two magnetic poles and divert the magnetic field. 35–04 Axle Lubricant and Filter Change, and Magnetic Strainer Cleaning and Check 4.2 Clean away the collected material depos- ited on each pole. Magnets will rapidly lose their effectiveness as collected mate- rial bridges the gap between the two poles. 4.3 After the first oil is changed, inspect the drain plug each time for large quantities of metal particles.

NOTICE When operating under adverse conditions, it may be necessary to change the axle lubricant at more frequent intervals than listed in the scheduled maintenance tables. Failure to do so could result in axle damage. Detroit 4.4 After cleaning, install the drain plug(s) and tighten to 30 lbf·ft (41 N·m). 5. Fill the axle with the recommended lubricant. See Table 1 for recommended drive axle lubri- cants and Table 2 for lubricant capacities. IMPORTANT:

On Detroit axles, the oil change interval for long haul vehicles can be extended to 500,000 miles (800 000 km) for axles with weight ratings of 34,000 to 40,000 lb (15 000 to 18 000 kg) using synthetic lubricant if a lubricant analysis shows adequate quality. Oil must be changed at least every four years, and more often if the axle is exposed to high temperatures and steep grades. NOTE: Some Detroit axles have a small tapped and plugged hole near and below the housing oil fill hole. This smaller hole is for a lubricant temperature indicator only, and should not be used as a fill or level hole. 5.1 Fill the axle through the oil fill hole.

Lubri- cant should be level with the bottom of the oil fill hole. To check fluid level, see Fig. 4 . 5.2 Install and tighten the fill plug 30 lbf·ft (41 N·m). Meritor Axles 1. Park the vehicle on a level surface, shut down the engine, and set the parking brake. Chock the tires. 2. Clean the fill plug and the area around it. In the axle housing rear cover, remove the plug from the oil fill hole. See Fig. 1 . IMPORTANT: If using synthetic lubricant, the lubricant change interval is extended to 100,000 miles (160 000 km). On axles with a pump and filter system, the filter change interval is 100,000 miles (160 000 km). CAUTION Be careful when draining the axle oil.

It may be very hot, and could cause personal injury if it con- tacts the skin. 1. Park the vehicle on level ground, apply the park- ing brakes, and chock the front tires. 3. Place a drain pan under the rear axle drain plug. Drain the oil when it is warm. At this tempera- ture, the oil will run more freely and ensure that the axle is flushed. NOTE: Some Meritor axles have a small tapped and plugged hole near and below the housing lubricant fill hole. This smaller hole is for a lubri- cant temperature indicator only, and should not be used as a fill or level hole. 4. Clean the fill and drain plugs. Change them if necessary. 2. Clean the area around the fill plug, then remove the fill plug.

Western Star Maintenance Manual, September 2015 35/5