Rear Axle 35 3. Place a drain pan under the drain plug, then re- move the drain plug from the bottom of the hous- ing. Completely drain the lubricant while the unit is warm, to allow the lubricant to drain faster. each pole. Magnets will rapidly lose their effectiveness as collected material bridges the gap between the two poles. On tandem-drive axles, it is also necessary to remove the plug at the bottom of the interaxle differential housing to drain that lubricant. 5.3 Meritor recommends plugs with elements having a minimum pickup capacity of 1.5 pounds (0.7 kg) of low-carbon steel.
Each time the oil is changed, replace any mag- netic drain plug that does not meet the minimum pickup capacity. 4. If equipped with an oil pump, replace the filter. NOTE: There may be about one pint (0.5 L) of lubricant remaining in the filter. 5.4 Install the drain plug(s) and tighten to 35 lbf·ft (47 N·m). 4.1 Remove the axle oil filter using a suitable filter strap wrench (see Fig. 7 ) and dis- card it. 6. Fill the axle with recommended lubricant as fol- lows. For lubricant capacities, see Table 4 (single axles) or Table 5 (tandem axles). See Table 3 for recommended lubricant. 4.2 Using recommended drive axle lubricant (see Table 3 ), coat the face of the gasket on the new oil filter.
6.1 With the vehicle on a level surface, fill the axle through the oil fill hole. Allow a few minutes for the oil to flow into the axle. Lubricant should be level with the bottom of the oil fill hole. 4.3 Install the filter over the adapter, and tighten the filter one full turn after the gasket contacts the base; do not overtighten. 6.2 Check the fluid level; see Fig. 4 . 6.3 Install and tighten the fill plug 35 lbf·ft (47 N·m). 7. Whenever the interaxle differential housing has been drained, add an additional 2 pints (0.9 L) of the recommended lubricant directly into the inter- axle differential housing. 8.
Remove the chocks, then drive the vehicle, un- loaded, for 1 or 2 miles (2 or 3 km) at speeds not to exceed 25 mph (40 km/h), to thoroughly circulate lubricant throughout the carrier and housing assemblies. Dana Spicer Axles NOTE: If using a Roadranger synthetic drive axle lubricant, the lubricant change interval is extended to 180,000 miles (288 000 km). f350119a 05/27/93 Fig. 7, Meritor Axle Oil Filter Removal 5. Clean the fill and drain plugs as follows. Change them if necessary. 1. Park the vehicle on level ground, set the parking brakes, and chock the tires. NOTE: Some Dana Spicer axles have a small tapped and plugged hole near and below the housing oil fill hole.
This smaller hole is for a lubricant temperature indicator only, and should not be used as a fill or level hole. 5.1 For magnetic plugs, use a piece of key stock or any other convenient steel slug to short the two magnetic poles and divert the magnetic field. 5.2 Check the drain plug for metal particles every 100,000 miles (160 000 km). Clean away the collected material deposited on 2. Clean the oil fill plug and the area around it (see Fig. 3 ), then remove it from the oil fill hole. Western Star Maintenance Manual, September 2015 35/6