Driveline 41 Safety Precautions DANGER 1 When working on the vehicle, shut down the en- gine, set the parking brake, and chock the tires. Before working under the vehicle, always place jack stands under the frame rails to ensure the vehicle can not drop. Failure to follow these steps could result in serious personal injury or death. 2 M E R I T O R 41–01 Driveline Inspection 1. Park the vehicle on a flat, level surface, apply the parking brakes, and chock the tires.
1 1 f410155a 04/13/98 Due to the extreme load occurring at high-speed rotation, a loose or broken capscrew at any point in the driveline will weaken the driveline connec- tion, which could eventually result in serious ve- hicle damage. Do not over-tighten bearing-cap capscrews or yoke-strap capscrews. 1. Self-Locking Capscrew 2. Adhesive Band Fig. 1, Meritor U-Joint Fasteners for Bearing Caps 2. For driveline universal joints with bearing caps, tighten bearing-cap capscrews 43 lbf·ft (49 N·m). See Fig. 1 , item 1. For RPL series universal joints, tighten bearing- cap capscrews 125 lbf·ft (169 N·m). See Fig. 2 .
For driveline universal joints with yoke straps, tighten yoke-strap capscrews 125 lbf·ft (169 N·m). See Fig. 3 . 3. Check the driveline yokes for cracks, and check end-yokes for looseness. See Fig. 3 . f410182 12/09/97 Have any cracked yokes replaced by an autho- rized Western Star dealer. Fig. 2, Meritor RPL Series U-Joint If any end-yoke can be moved in or out on its shaft, or can be rocked on its shaft, take it to an authorized Western Star dealer for service. to side. If the bearing is loose on its shaft, or rattles, have it replaced. If the bearing mount is loose on the frame, have your Western Star dealer tighten the mounting fasteners to the proper torque value.
Have the midship bearing assembly replaced if the rubber cushion is dete- riorated or oil-soaked. 4. Check U-joint assemblies for wear by moving the driveshaft up and down, and from side to side. If any movement of the U-joint cross in the bear- ings can be felt or seen, have the U-joint assem- bly replaced. 6. Check slip joints for spline wear by moving the sleeve-yoke and splined shaft back and forth. See Fig. 4 . If the slip joint can be twisted in a clockwise or counterclockwise movement greater 5.
Check if the midship bearing and mounting are loose or have deteriorated, by attempting to move the driveshaft up and down, and from side Western Star Maintenance Manual, September 2015 41/1 CAUTION