Driveline 41 14 15 13 7 8 9 3 16 12 11 1 2 4 5 6 10 05/01/95 3 f410067b NOTE: Not all fasteners are shown. 1. Transmission 2. Transmission Output-Shaft End-Yoke (yoke-strap type) 3. U-Joint Assembly 4. Bearing Cap Self-Locking Capscrew 5. Bearing Cap 6. U-Joint Cross 7. Bearing Cup (for yoke strap) 8. Yoke Strap and Capscrew 9. Slip-Joint Assembly 10. Sleeve-Yoke (bearing-cap type) 11. Dust Cap 12. Splined Stub Shaft 13. Driveshaft Tube 14. Tube-Yoke (bearing-cap type) 15. Axle Input-Shaft End-Yoke (yoke-strap type) 16. Rear Axle than 0.007 inch (0.18 mm), have both the sleeve-yoke and the splined shaft replaced. Fig. 3, Components of a Basic Driveline 9.
For driveshafts with slip joints, check to be sure the yoke plug is not loose or missing. See Fig. 5 , item 2. Have your Western Star dealer repair or replace the yoke plug as needed. If the yoke plug is missing, the splined shaft may be hitting the plug and knocking it out; have your Western Star dealer determine the correct driveshaft length. 7. Visually examine the driveshaft tubes for dents, bends, twists, or other damage. If any tube ap- pears to be damaged, have it repaired or re- placed by an authorized Western Star dealer. 8. Examine the driveshaft for evidence of missing balance weights, and for build-up of foreign ma- terial. Remove any foreign material.
If there is any evidence that balance weights are missing, have the driveshaft removed and balanced. Western Star Maintenance Manual, September 2015 41/2