Driveline 41 5 1 3 4 2 3 7 f410012a 05/27/93 Attempt to move the sleeve-yoke and splined shaft back and forth. 6 41–02 Driveline Lubrication Fig. 4, Slip Joint Spline Wear Checking 3 1 8 Universal Joint Lubrication A NOTE: Vehicles equipped with Meritor RPL Se- ries drivelines do not require periodic lubrication. f410050a 10/20/93 1. Park the vehicle on a flat surface, apply the park- ing brakes, and chock the tires. A. After grease appears, cover the pressure-relief hole while continuing to lubricate. 1. Slip Joint Grease Fitting (with grease gun attached) 2. Yoke Plug 3. Grease 4. Half-Round Yoke 5. Yoke Plug Pressure-Relief Hole 6. Slip Joint Seal 7. Full-Round Yoke 8.
U-Joint Grease Fitting 2. Wipe all old grease and dirt from each U-joint grease fitting. See Fig. 5 , Ref. 8. 3. Use a hand-type grease gun, or a high-pressure gun with a low-pressure adapter, to lubricate U-joints. If a low-pressure adapter is not used, U-joints may not receive enough grease. Fig. 5, Slip Joint and U-Joint Lubrication Using lithium 12-Hydroxy stearate grease (NLGI Grade 1 or Grade 2, with EP additives), lubricate until new grease can be seen at all four U-joint seals. Fresh grease must be seen escaping from all four bearing-cap seals of each U-joint.
On yokes equipped with a yoke-bearing cap, if most of the grease being added to a U-joint can be seen escaping from just one of the U-joint seals, check the torque on the capscrews at that seal. with a plastic or rawhide mallet on the side oppo- site the dry seal, while continuing to lubricate. If grease still does not appear, loosen the cap- screws at the bearing with the dry seal, to relieve seal tension. Lubricate the U-joint until new grease is seen at the seal, then tighten the cap- screws to the correct torque specifications. If the bearing will not take grease, have the U-joint re- placed. 4. Tighten the bearing-cap capscrews 43 lbf·ft (49 N·m).
If the capscrews were already tight, or all of the U-joint seals still do not purge, remove the bearing cap at that seal, and examine the seal for damage. If the seal is damaged, replace the complete U-joint. 6. Check the purged grease. If it appears rusty, gritty, or burned, have the U-joint replaced. 7. Wipe the purged grease from the seals, and any excess grease from the grease fitting. 5. If grease does not appear at one seal, use a pry- ing tool to pry the U-joint trunnion away from the non-purging seal, or tap the driveshaft or yoke Western Star Maintenance Manual, September 2015 41/3