Brakes 42 6 2 properly aligned and allow the cartridge to rest flush against the end cover. 11. Using a wrench or socket, tighten the desiccant cartridge bolt 70 lbf·ft (95 N·m). Do not over- tighten. 4 5 12. Before placing the vehicle in service, perform the test below. 12.1 Close all reservoir drain cocks. 1 & 9 3 12.2 Build system pressure to governor cut- out, and note that the AD-IP air dryer purges with an audible escape of air. 12.3 Fan the service brakes to reduce system air pressure to governor cut-in. Note that the system once again builds to full pres- sure and is followed by a purge at the AD-IP air dryer exhaust.
7 8 09/20/94 f420544a 12.4 Check for excessive leakage around the head of the desiccant cartridge where it contacts the end cover. With the com- pressor in loaded mode (compressing air), apply a soapy solution to these areas, and observe that any leakage does not exceed a 1-inch bubble in 1 second. If leakage exceeds this measure, remove and re-install the desiccant cartridge. Bendix AD-9si, AD-IS and CR Turbo 2000 Air Dryers Fig. 3, End Cover to Housing Torque Pattern 4. Remove and discard both O-rings from the car- tridge bolt. 5. Using a clean rag, wipe clean the inside of the end cover.
Clean the cartridge bolt bore in the end cover, and the sealing surfaces for the large- and small-diameter desiccant cartridge sealing rings. 6. Inspect the end cover for physical damage, then inspect all air line fittings for corrosion; replace as necessary. 7. Clean and inspect the bolt, paying attention to the threads and O-ring grooves. 1. Park the vehicle on a level surface, shut down the engine, and set the parking brake. Chock the tires. IMPORTANT: Use only the grease supplied with Bendix replacement kits. 2. Drain the air reservoirs. 8. Lubricate the O-rings, bolt O-ring grooves, seal- ing rings, and cartridge grooves. Lubricate the end cover bore for the bolt. 3.
Using a strap wrench or equivalent, loosen the desiccant cartridge. See Fig. 4 . Spin the car- tridge off by hand and discard it. 9. Install both O-rings on the cartridge bolt, then, using a twisting motion, insert the assembled desiccant cartridge bolt in the end cover. 4. On the new desiccant cartridge, lubricate the sealing rings with silicone grease. IMPORTANT: Only use the silicone grease sup- plied with Bendix replacement kits. 10. Install the desiccant cartridge on the end cover, making sure the cartridge is properly seated and flush on the end cover. NOTE: It may be necessary to rotate the car- tridge slightly until the anti-rotation lugs are 5.
Screw the desiccant cartridge onto the body by hand until the seal makes contact with the body. Rotate the cartridge clockwise about one full turn. Tighten the cartridge firmly. Western Star Maintenance Manual, September 2015 42/4