Brakes 42 1 2 3 2 1 3 04/16/98 f421910 1. Desiccant Cartridge 2. Cartridge Sealing Ring 3. Threaded Base Post 08/05/94 f421292 1. Seal 2. O-Ring 3. Air Dryer Base Fig. 4, Desiccant Cartridge Replacement Fig. 5, Desiccant Cartridge Replacement, WABCO Air Dryers WABCO System Saver 1200, 1200 Plus, and Twin Air Dryers IMPORTANT: If the air dryer base is damaged, preventing a tight seal, replace the air dryer. NOTICE 5. Using a multipurpose, high-temperature grease that resists water, steam, and alkali, lightly coat the surfaces of the new O-ring and the dryer base. Install the O-ring. The WABCO System Saver air dryers can use ei- ther a standard or oil coalescing desiccant car- tridge.
When replacing the desiccant cartridge, it is very important to use the same type of car- tridge that was originally installed on the dryer. Oil coalescing cartridges can be used in any applica- tion, but require more frequent service intervals (every 1 to 2 years instead of every 2 to 3 years for a standard cartridge). Do not replace an oil co- alescing cartridge with a standard cartridge, as this may result in contamination and malfunction- ing of downstream air system components. 6. Thread the desiccant cartridge onto the dryer base (turn clockwise). When the seal contacts the base, tighten the cartridge one complete turn more. Do not overtighten.
42–04 Alcohol Evaporator Cleaning and Inspection Refer to Fig. 5 for cartridge replacement. Midland 1. Drain the air system. 2. Using a strap wrench, turn the desiccant car- tridge counterclockwise and remove it. Maintenance is required during both the freeze sea- son and the off season to keep the alcohol evapora- tor in good working order. Off Season 3. Remove and discard the O-ring. 4. Clean the top surface of the dryer base with a commercial cleaning solvent. During the off season, drain the unit of alcohol. At regular engine service intervals, open the drain cock to remove moisture from the alcohol evaporator. Be- Western Star Maintenance Manual, September 2015 42/5