Brakes 42 fore reactivating the evaporator for the next freeze season, drain, disassemble, inspect, and steam- clean the unit of any sludge that may have accumu- lated. It is advisable to replace any rubber parts when assembling the alcohol evaporator. Perform this service just before the freeze season. Freeze Season Reactivation For camshaft brackets with grease fittings, use an NLGI Grade 1 or Grade 2 multipurpose chassis grease. Lubricate the camshaft bushings through the grease fitting on the camshaft bracket or the spider until new grease flows from the inboard seal. See Fig. 6 . 1. Park the vehicle on a level surface and apply the parking brakes. Shut down the engine. Chock the tires.
1 2. Remove the filler cap, and check the cap tet- raseal. 3. Remove the capscrews and reservoir from the cover. 3 4. Remove the cover tetraseal. 5. Drain the air tank, and disconnect the line from the evaporator outlet. Remove the check-valve retainer, spring, and disc. 2 6. Install the disc, spring, and check-valve retainer, and connect the line to the evaporator outlet. f420011a 05/28/93 A. Grease Exit 1. Brake Chamber 2. Slack Adjuster 3. Non-Pressure-Relief Grease Fitting A 7. Install the cover tetraseal. 8. Install the reservoir on the cover and tighten the capscrews. Fig. 6, Camshaft Bracket Lubrication 9.
Fill the reservoir with 40 ounces (1183 mL) of methyl alcohol, then install the filler cap. WARNING 10. Remove the chocks from the tires. If grease leaks out under the camhead, the cam- shaft bracket grease seal is worn or damaged and should be replaced. If this seal is not replaced, the brake linings could become contaminated with grease. The stopping distance of the vehicle will be increased, which could result in personal injury or property damage. 42–05 Camshaft Bracket Lubrication IMPORTANT: Perform MOP 42–07 before lubri- cating the camshaft brackets. 42–06 Slack Adjuster Lubrication NOTE:
If equipped with a Meritor extended- maintenance Q Plus brake system, the cam- shaft bracket will not have a grease fitting. These camshafts use a special NLGI Grade synthetic polyurea grease, and do not require lubrication for 3 years or 500,000 miles (800 000 km), whichever comes first. The extended maintenance camshaft bushings are lubricated during the brake reline service interval. IMPORTANT: Perform MOP 42–07 before lubri- cating the slack adjusters. Slack adjusters that have a grease fitting must be lubricated periodically to ensure proper brake opera- tion. Western Star Maintenance Manual, September 2015 42/6