Daimler Trucks North America LLC Western Star — Western Star

Brakes 42 WARNING For operating temperatures between (–29°C) and (–40°C), use Lubriplate Aero grease. Failure to lubricate slack adjusters could lead to dragging brakes or a brake failure, resulting in property damage, personal injury, or death. Dana Spicer and Haldex Lubricate a Gunite slack adjuster at the grease fitting until grease appears on the camshaft, or flows from the grease relief. See Fig. 8 . CAUTION 4 5 Do not use moly-disulfide-loaded grease or oil. Both the life and reliability of the slack adjuster will be reduced if this type of grease is used. 6 Lubricate the slack adjuster at the grease fitting. See Fig. 7 . Use standard chassis lubricant for Haldex slack adjusters.

Dana Spicer Low Lube slack adjust- ers should be lubricated with SHC 460 synthetic lubricant. 7 3 8 2 9 1 1 10 10/27/93 f420653a 1. 7/16" Adjusting Nut 2. Grease Fitting 3. Boot 4. Link 5. Brake Chamber Piston Rod 6. Clevis 7. 1/2" Clevis Pin 8. 1/4" Clevis Pin 9. Grease Relief Opening 10. Slack Adjuster Spline 2 Fig. 8, Gunite Slack Adjuster The newest Gunite slack adjusters are produced without a grease relief. During lubrication with a grease gun, the lubricant is forced through the drilled worm wheel onto the camshaft. Lubricate the slack adjuster at the grease fitting until grease appears on the camshaft. See Fig. 8 . 02/01/2001 f421649a 1. Grease Fitting 2. Slack Adjuster Fig.

7, Dana Spicer Slack Adjuster Gunite Meritor For operating temperatures of (–29°C) and higher, use Texaco Multifak EP-2 or Mobil Grease No. 77. NOTE: If equipped with an extended- maintenance Q Plus brake system, the slack adjuster will not have a grease fitting. These Western Star Maintenance Manual, September 2015 42/7