Daimler Trucks North America LLC Western Star — Western Star

Brakes 42 slack adjusters use a special NLGI Grade syn- thetic polyurea grease, and do not require lubri- cation for 3 years or 500,000 miles (800 000 km), whichever comes first. The extended- maintenance slack adjusters are lubricated dur- ing the brake reline service interval. 42–07 Brake Inspection IMPORTANT: This procedure should be per- formed prior to lubrication of the brake compo- nents. For slack adjusters with grease fittings and for oper- ating temperatures above (–40°C), use a NLGI Grade 1 clay-base grease or a NLGI Grade 1 and 2 lithium-base grease.

Parking Brake Operational Check For slack adjusters with grease fittings and for oper- ating temperatures below (–40°C) and above (–54°C), use a NLGI Grade 2 synthetic oil, clay-base grease. Perform the following check in a clear safe area. If the parking brakes fail to hold the vehicle, per- sonal injury or property damage may result. 1. With the engine running, and air pressure at cut- out pressure, set the parking brake. Lubricate the slack adjuster at the grease fitting until grease is forced past the pressure-relief capscrew or past the gear splines around the inboard snap ring. See Fig. 9 . 2. Put the vehicle in the lowest gear and gently at- tempt to move it forward.

The vehicle should not move. If the vehicle moves, the parking brakes are not operating correctly and must be repaired before the vehicle is returned to service. See Group 42 of the Western Star Workshop Manual for repair procedures. Brake Component Inspection 1 2 3 1. Park the vehicle on a level surface, set the park- ing brake, and chock the tires. Once the tires are chocked, release the parking brake. 4 WARNING 5 Manually adjusting an automatic slack adjuster to bring the pushrod stroke within legal limits is likely masking a mechanical problem. Adjustment is not repairing.

Before adjusting an automatic slack adjuster, troubleshoot the foundation brake system and inspect it for worn or damaged com- ponents. Improperly maintaining the vehicle brak- ing system may lead to brake failure, resulting in property damage, personal injury, or death. 7 f420012a 10/20/93 6 1. Brake Chamber 2. Clevis 3. Actuator Rod 4. Boot 5. Pressure-Relief Capscrew, Gasket, Pawl Spring, and Pawl 6. Manual Adjusting Nut 7. Grease Fitting (or plug) 2. With the engine off, and 100 psi (689 kPa) of air tank pressure, have an assistant apply and hold an 80 to 90 psi (550 to 620 kPa) brake applica- tion. Fig. 9, Meritor Slack Adjuster 3.

Check to see if the colored over-stroke band on each brake chamber pushrod is exposed. If a band shows, the stroke is too long. Check the foundation brake components for wear or damage, and repair as needed. See Group 42 of Western Star Maintenance Manual, September 2015 42/8 CAUTION