Steering 46 Safety Precautions DANGER When working on the vehicle, shut down the en- gine, set the parking brake, and chock the tires. Before working under the vehicle, always place jack stands under the frame rails to ensure the vehicle can not drop. Failure to follow these steps could result in serious personal injury or death. 2 f461072 11/27/95 1 1. Grease Fitting at Pitman Arm 2. Grease Fitting at Axle Steering Arm 46–01 Drag Link Inspection 46–03 Power Steering Fluid and Filter Changing Fig. 1, Drag Link WARNING All steering system components are critical for safe operation of the vehicle.
Failure to maintain the steering system as specified may result in loss of steering control, which could lead to per- sonal injury and property damage. WARNING Fill only with approved clean fluid. Failure to use the proper fluid could cause seal deterioration and leaks. Fluid leaks could eventually cause loss of power steering assist. This could lead to an acci- dent resulting in personal injury or property dam- age. Wear eye protection when changing the fluid and filter. Cylindrical Reservoir, Bottom Return Port ( Fig. 2 ) Have someone turn the steering wheel from left to right. Check for movement between the ball stud end at both the pitman arm and the steering arm.
Also check if the ball stud nut is loose. If the ball stud end is loose, replace the drag link. If the ball stud nut is loose, replace the nut and cotter key. See Group 00 for proper torque specifications. Inspect the boot of the drag link at both the pitman arm and the steering arm end for cracks, splits, or other damage. Replace the boot as needed. 1. Set the parking brake and chock the rear tires. 2. Raise the front of the vehicle and support it with jack stands. Grasp the drag link near the pitman arm end, then push and pull laterally to check for axial movement in the ball stud end. If it is loose, replace the drag link.
If there is 1/8-inch (3-mm) movement or more, do not drive the vehicle until the drag link has been re- placed. 3. Put the vehicle in neutral. 4. Open the hood. 5. Wipe down the area around the steering gear and related hydraulic lines. 6. Place a drain pan under the steering gear and power steering reservoir. 46–02 Drag Link Lubrication 1. Using a clean rag, wipe all dirt from both drag link grease fittings. See Fig. 1 . 7. Remove the pressure line and return hose (see Fig. 3 ) from the steering gear and allow the oil to drain. 2. Using a pressure gun, apply clean grease at the grease fittings until old grease is forced out of the socket.
Use multipurpose chassis grease NLGI Grade 2 (8% 12-hydroxy lithium stearate grease) or NLGI Grade 1 (6% 12-hydroxy lithium stearate grease); Grade 2 is preferred. 8. Loosen the clamp, and remove the cover along with the filter spring and the filter top plate. Do not use pliers to aid in removal of the filter; pliers could cause metal chips to enter the steering system. Western Star Maintenance Manual, September 2015 46/1