Steering 46 11. Connect the pressure line and return hose to the steering gear. 12. Install a new filter into the reservoir. Position the new filter with the larger opening up. 13. Clean the reservoir cover and gasket. Inspect the O-ring and the cover for cracks, deformities, or damage. Replace the gasket seal or cover as needed. 14. Install the reservoir cover along with the spring and the top plate. Make sure the center of the top plate fits into the opening at the top of the filter. 1 15. Place the clamp over the flanges of the cover and shell assembly, then tighten 25 to 30 lbf·ft (35 to 40 N·m). 2 16. Fill the reservoir with an approved power steer- ing fluid.
See Table 1 for approved power steer- ing fluids. Approved Power Steering Fluids 02/10/2015 f462251 1. Pressure Line 2. Return Hose Fluid Type Approved Fluid Dexron® III Automatic Transmission Fluid Super ATF Fig. 2, Power Steering Reservoir, Side View TES-389 17. With the engine off, turn the steering wheel from full left to full right three times. Add more power steering fluid as needed. Table 1, Approved Power Steering Fluids 1 18. Start the engine and operate the engine at idle. Check the power steering fluid and add more fluid if needed. 19. Turn the steering wheel from full left to full right several times. Add fluid to the reservoir as needed to maintain the fluid level.
02/10/2015 f462251a 2 20. Shut down the engine. 1. Pressure Line 2. Return Hose 21. Raise the vehicle, remove the jack stands, and lower the vehicle. Flat Reservoir, Top Return Port Fig. 3, Power Steering Reservoir, Top View 9. Remove the filter. It may be necessary to wiggle the filter to remove it from its base. 1. Set the parking brake and chock the rear tires. 2. Raise the front of the vehicle and support it with jack stands. 10. Turn the steering wheel from full left to full right three times to purge oil from the gear. 3. Put the vehicle in neutral. 4. Open the hood. Western Star Maintenance Manual, September 2015 46/2