Steering 46 For filter caps with a separate retaining ring, hand-tighten the filter, then turn it an additional 1/4 turn. 1 2 For one-piece filter caps, the filter is not threaded. 13. With the engine off, turn the steering wheel from full left to full right three times. Add more power steering fluid as needed. 3 14. Start the engine and operate the engine at idle. Check that the power steering fluid level is be- tween the MIN COLD and MAX HOT lines. Add more power steering fluid if needed. 4 15. Turn the steering wheel from full left to full right several times. Add fluid to the reservoir as needed to maintain the fluid level between the MIN COLD and MAX HOT lines. 02/03/2015 f462253a 1.
Reservoir 2. Filter Cap 3. Pressure Line 4. Return Hose 16. Shut down the engine. Fig. 4, Power Steering Reservoir 17. Raise the vehicle, remove the jack stands, and lower the vehicle. 5. Wipe down the area around the steering gear and related hydraulic lines. 6. Place a drain pan under the steering gear and power steering reservoir. 46–04 Steering Shaft Lubrication 7. Remove the pressure line and return hose (see Fig. 4 ) from the steering gear and allow the oil to drain. IMPORTANT: Only steering shafts with zerk fit- tings should be lubricated. Shafts without zerk fittings come with grease sealed inside and should not be greased. 8.
Remove the filter cap from the reservoir, then remove and discard the filter. Filter caps with a separate retaining ring have a threaded connection with the filter. Unscrew the filter and discard it. IMPORTANT: Some vehicles may have addi- tional U-joints on the steering column or stub- shaft. These should also be lubricated at this interval. One-piece filter caps do not have a threaded fit with the filter. Pull off the filter and discard it. 1. Open the hood and locate the lower steering shaft U-joint grease fitting. 9. Turn the steering wheel from full left to full right three times to purge oil from the gear. 2. Using a clean rag, wipe all dirt from the grease fitting. 10.
Connect the pressure line and return hose to the steering gear. 3. Using a pressure gun, apply clean grease at the grease fitting until old grease is forced out of the seals. Use multipurpose chassis grease NLGI Grade 2 (8% 12-hydroxy lithium stearate grease) or NLGI Grade 1 (6% 12-hydroxy lithium stearate grease); Grade 2 is preferred. See Fig. 5 . 11. Fill the reservoir with an approved power steer- ing fluid to the line between the MIN COLD and MAX HOT lines. See Fig. 4 . See Table 1 for ap- proved power steering fluids. 4. Locate the upper steering shaft slip joint and U-joint grease fittings. 12.
Apply a thin film of power steering fluid on the gasket of the new filter, then attach the filter to the filter cap and install the cap on the reservoir. 5. Using a clean rag, wipe all dirt from the grease fittings. Western Star Maintenance Manual, September 2015 46/3