Steering 46 6. Using a pressure gun, apply clean grease at both grease fittings until old grease is forced out of the seals. Use multipurpose chassis grease NLGI Grade 2 (8% 12-hydroxy lithium stearate grease) or NLGI Grade 1 (6% 12-hydroxy lithium stearate grease); Grade 2 is preferred. See Fig. 6 . 1 3 2 1 08/16/2001 f461912 1. Slip Joint Grease Fitting 2. U-Joint Grease Fitting Fig. 6, Steering Shaft, Inside the Cab 08/16/2001 f461913 1. Steering Gear 2. U-Joint Grease Fitting 3. Steering Shaft 1 Fig. 5, Steering Shaft, Under-Hood 46–05 Power Steering Gear Lubrication TRW TAS Series Apply grease to the sector shaft only with a hand- type grease gun. See Fig. 7 .
Use of a high- pressure power grease gun will supply grease too quickly and could affect the high pressure seal, contaminating the hydraulic fluid. 11/28/95 f461071 1. Sector Shaft Grease Fitting Fig. 7, TRW TAS Series Sector Shaft Lubrication Using a hand-type grease gun, apply NLGI Grade 2 or 3 multipurpose chassis grease until it starts to come out past the sector shaft seal. Western Star Maintenance Manual, September 2015 46/4 2 CAUTION