Fuel 47 Safety Precautions sibly resulting in personal injury or property dam- age. When working on a fuel system, have a fire extinguisher within easy reach. DANGER 5. Disconnect the wiring harnesses from the water- in-fuel sensor and, if equipped, the heater. See Fig. 1 . When working on the vehicle, shut down the en- gine, set the parking brake, and chock the tires. Before working under the vehicle, always place jack stands under the frame rails to ensure the vehicle can not drop. Failure to follow these steps could result in serious personal injury or death. 6. Spin off the sight bowl and the filter element as a unit. Remove the O-ring from the top of the filter element. 7.
Remove the sight bowl from the filter element. Clean the O-ring seating surface. 47–01 Fuel Filter Replacement 8. Apply a thin coating of clean diesel fuel or en- gine oil to the O-rings. Refer to the engine manufacturer’s service manual for removal and installation procedures. 9. Spin the sight bowl onto the new filter element and then fill the filter element and sight bowl as- sembly with clean diesel fuel. 47–02 Fuel Separator Sight Bowl Cleaning and Element Replacement 10. Spin the entire assembly onto the mounting head and tighten by hand until snug. 11. Connect the wiring harnesses for the water-in- fuel sensor and, if equipped, the heater. Alliance/Racor 12.
Prime the fuel/water separator, as follows. The only maintenance necessary on an Alliance or Racor fuel/water separator is to replace the filter element. If equipped with a primer pump, operate the primer pump until fuel comes out at the drain. If not equipped with a primer pump, fill the filter element and sight bowl with clean fuel and crank the engine until it starts. 1. Park the vehicle on a level surface, shut down the engine, and set the parking brake. Chock the tires and open the hood. 13. Start the engine and check for leaks. 2. Place a suitable container under the fuel/water separator. 14. Shut down the engine and repair any leaks.
DAVCO Fuel Pro® 382 and 482, and Diesel Pro® 243 IMPORTANT: When draining fluid from a fuel/water separator, drain the fluid into an ap- propriate container, and dispose of it properly. Many jurisdictions now issue fines for draining fuel/water separators onto the ground. NOTE: In the event of an emergency, when the filter needs replacement but a DAVCO filter is not available, a temporary filter can be used; see Chapter 21 of the Western Star Driver’s Manual for instructions. 3. Turn the drain plug counterclockwise to open it. 4. When the fuel/water separator is completely drained, turn the drain plug clockwise to close it.
WARNING WARNING Diesel fuel is flammable and can ignite if exposed to an open flame, intense heat, or other ignition source. Do not drain fuel near, or expose fuel vapor to open flame or intense heat. Exposure to open flame or intense heat could start a fire, pos- Fluid circulated through the fuel/water separator to heat the fuel may be diesel fuel returned from the engine, or engine coolant. Drain the fuel/water separator only when the engine and fluids have cooled. Draining it when the engine is hot could cause severe personal injury due to scalding. Western Star Maintenance Manual, September 2015 47/1