Fuel 47 with the fuel system near, open flame or intense heat. To do so could cause fire, possibly resulting in serious personal injury or property damage. 1 The filter element should be changed only when the fuel level has reached the top of the filter element. There is no significant restriction to fuel flow until the element is completely clogged. 2 1. Park the vehicle on a level surface, shut down the engine, and set the parking brake. Chock the tires and open the hood. 2. Check the fuel level in the fuel filter. Replace the fuel/water separator element only when the filter element is completely covered.
If the fuel level has reached the top of the filter element, follow the procedure below to replace the element. 3 3. Put a clean receptacle under the fuel/water sepa- rator and attach a piece of hose to the drain valve, to direct fuel into the receptacle. The drain valve has a 1/2-inch (12.7-mm) pipe; use a hose with a 1/2-inch pipe thread to fit cor- rectly. 4 4. Remove the vent cap ( Fig. 2 , Item 4) and open the drain valve ( Fig. 2 , Item 1) to drain the fuel completely, then close the drain valve. 3 5 5 7 9 8 6 2 01/27/2011 f470566 6 1. Primer Pump 2. Mounting Head 3. O-Ring 4. Filter Element 5. Sight Bowl 6. Water-in-Fuel Sensor 7. Wiring Harness, Water-in-Fuel Sensor 8.
Wiring Harness, Heater 9. Drain Plug f470506b 05/05/2009 1. Drain Valve 2. Lower Housing 3. Clear Cover 4. Vent Cap 5. Collar 6. Inlet Port/Check Valve Fig. 1, Fuel/Water Separator Assembly, Alliance/Racor If returning fuel is released into the atmosphere, its vapors can ignite in the presence of any igni- tion source. Do not expose the fuel to, or work Fig. 2, DAVCO Fuel/Water Separator (Fuel Pro 382 Shown) Western Star Maintenance Manual, September 2015 47/2 4 1