Daimler Trucks North America LLC Western Star — Western Star

Fuel 47 5. Using a DAVCO Collar Wrench ( Fig. 3 ), remove the clear cover and collar. increase engine speed to high idle for one to two minutes to purge air from the system. VENT CAP FOR REMOVAL OF TOP COLLAR ONLY 11.5 While the engine is running, and after the air is purged from the system, loosen the vent cap until the fuel level falls to about one inch (2.5 cm) above the collar, then hand-tighten the vent cap. 11.6 Check for leaks and shut down the engine. ConMet Fuel Separator Sight Bowl Cleaning 02/16/2009 f470277 Fig. 3, DAVCO Collar Wrench The only maintenance necessary on ConMet fuel separators is to clean the sight bowl, if equipped. See Fig. 7 . NOTE:

Broken vent cap and collar warranty claims will not be accepted if any tool other than a DAVCO Collar Wrench is used for removal. During installation, the vent cap and collar are to be hand-tightened only , not tightened with a wrench. Use part number 482017 on Fuel Pro 482 units; part number 380134 on Fuel Pro 382 units. WARNING Diesel fuel is flammable and can ignite if exposed to an open flame, intense heat, or other ignition source. Do not drain fuel near, or expose fuel vapor to open flame or intense heat. Exposure to open flame or intense heat could start a fire, pos- sibly resulting in personal injury or property dam- age.

When working on a fuel system, have a fire extinguisher within easy reach. 6. Remove the filter, cover O-ring, and vent cap O-ring. Dispose of them in an environmentally acceptable manner. See Fig. 4 , Fig. 5 , or Fig. 6. 7. Clean all threads and sealing surfaces very thor- oughly. Even a small amount of dirt will prevent the fuel/water separator from sealing, and an air leak may result. 1. Park the vehicle on a level surface, shut down the engine, and set the parking brake. Chock the tires and open the hood. IMPORTANT: When draining fluid from a fuel/water separator, drain the fluid into an ap- propriate container, and dispose of it properly.

Many jurisdictions now issue fines for draining fuel/water separators onto the ground. 8. On Fuel Pro 382 units, install the grommet on the bottom of the new filter. 9. Install the new filter and grommet assembly and cover O-ring on the housing. 10. Install the clear cover and the collar. Hand- tighten the collar. 2. Drain the fuel separator. 3. Unscrew the sight bowl from the fuel separator. 11. Prime the system. 4. Wipe the sight bowl clean using a soft cloth. 11.1 Ensure that the drain valve is closed. 11.2 Fill the housing to the top with clean die- sel fuel. 5. Lubricate the gasket with a film of oil, and rein- stall it on the sight bowl.

If the gasket appears dry-rotted or damaged, replace the gasket. 11.3 Install and hand-tighten the vent cap O-ring and vent cap. 6. Lightly lubricate the threads on the sight bowl with oil, then thread the sight bowl into the bot- tom of the fuel separator. 11.4 Start the engine. When the lubricating oil reaches its normal operating pressure, Western Star Maintenance Manual, September 2015 47/3