Exhaust 49 Safety Precautions Aftertreatment Device (ATD)—a housing that contains the DOC and DPF (also the SCR and the mixing tube in one-box systems). DANGER BlueTec®—Daimler’s proprietary SCR technol- ogy. When working on the vehicle, shut down the en- gine, set the parking brake, and chock the tires. Before working under the vehicle, always place jack stands under the frame rails to ensure the vehicle can not drop. Failure to follow these steps could result in serious personal injury or death. Diesel Oxidation Catalyst (DOC)—a flow- through device that oxidizes soot in the ATD. Diesel Particulate Filter (DPF)—a component in the ATD that traps soot from the exhaust gas.
Diesel Exhaust Fluid (DEF)—the chemical agent that reacts with the exhaust gases in the SCR to reduce NOx. 49–01 Exhaust System Inspection (Noise Emission Control) DEF Pump—filters and supplies DEF to the DEF metering unit. DEF Tank—holds DEF and regulates its tem- perature. In addition to inspecting the exhaust system at the scheduled maintenance interval, inspect the exhaust system if the noise level of the vehicle has in- creased. Western Star Trucks recommends replacing parts that show leakage, wear, or damage, with genuine Western Star parts. DEF Metering Unit—mixes DEF with com- pressed air, and meters this mixture into the exhaust flow via an injection nozzle.
SCR Catalyst—the housing containing a treated ceramic flow-through block where the DEF and exhaust gases undergo selective catalytic re- duction (SCR). The exhaust system must be free of leaks, binding, grounding, and excessive vibrations. These condi- tions are usually caused by loose, broken, or mis- aligned clamps, brackets, or pipes. If any of these conditions exist, check the exhaust system compo- nents and alignment. Align or replace as necessary; see Group 49 of the Western Star Workshop Manual , or take the vehicle to an authorized Freight- liner dealer. Selective Catalytic Reduction (SCR)—a process used to reduce NOx emissions.
Inspection To meet EPA10 emissions regulations for vehicles domiciled in the USA or Canada, engines manufac- tured after December 31, 2009 are equipped with an emission aftertreatment system. Vehicles domiciled outside of the USA and Canada may not have after- treatment equipment, depending upon local statutory emissions guidelines. It is a violation of US federal law to alter exhaust plumbing or aftertreatment in any way that would bring the engine out of compliance with certification requirements. (Ref: 42 U.S.C. S7522(a) (3).) It is the owner’s responsibility to maintain the vehicle so that it conforms to EPA regulations.
EPA10 Exhaust System Definitions of Aftertreatment (ATS) Terms IMPORTANT: The aftertreatment device (ATD), which is part of the aftertreatment system (ATS), requires special attention during regularly scheduled maintenance inspections. No leaks are allowed anywhere in the system. If any dis- crepancies are discovered, refer to the engine manufacturer’s service literature for repair in- structions. Refer to the following list of definitions of ATS terms and components. Aftertreatment System (ATS)—the entire ex- haust system from the turbocharger to the ex- haust stack or tail pipe. 1. Check for leakage at the clamp that attaches the exhaust pipe to the turbocharger exhaust outlet.
If leakage exists, tighten the nut on the clamp to Western Star Maintenance Manual, September 2015 49/1