Exhaust 49 the required torque. If leakage persists, install a new clamp. Diesel Exhaust Fluid (DEF) Filter Replacement 2. Check the exhaust pipe, bellows, and each ex- haust seal clamp for leakage, wear, cracks, or damage. Replace damaged components as needed. If leakage exists at a clamp, tighten the nuts to the required torque. If leakage persists, install a new exhaust seal clamp. Do not reuse seal clamps. Once a seal clamp is loosened or removed, it must be replaced. The Environmental Protection Agency’s 2010 regula- tions require lower nitrogen oxide (NOx) exhaust emissions.
Selective catalytic reduction (SCR) uses diesel exhaust fluid (DEF) to lower NOx emissions in the vehicle exhaust. A filter in the DEF pump pre- vents clogging of the DEF metering unit injection nozzle. 3. If present, check the condition of the insulation material around the exhaust pipe between the turbocharger and the ATD. See the engine manufacturer’s maintenance manual for filter replacement instructions and maintenance intervals. EPA07 Exhaust System Definitions of ATS Components 4. Check the ATD mounting bands for tightness. Tighten to 30 lbf·ft (41 N·m) if needed. Do not overtighten. 5.
Check for leaks around the clamps that attach the ATD in the ATS, and around the clamps that retain the DPF in the ATD. Refer to the following list of definitions of ATS com- ponents. Aftertreatment System (ATS)—the entire ex- haust system from the turbocharger to the ex- haust stack or tail pipe. 6. Check all sensors attached to the ATS for leaks or damaged wires. No leaks are allowed. See Fig. 1 , Fig. 2 , or Fig. 3 for Detroit Diesel ATS sensor locations. Aftertreatment Device (ATD)—a muffler-like can- ister that houses a DPF, DOC, and sensors. 7. Check the DPF exterior surface for dents or other damage.
A dent over 3 inches (76 mm) in diameter and 1/4-inch (6-mm) deep could cause internal damage to the DPF, causing it to malfunction. Diesel Particulate Filter (DPF)—a filter that col- lects and holds particulate matter (soot and ash). 8. Check the SCR catalyst for dents and other damage. Diesel Oxidation Catalyst (DOC)—oxidizes hy- drocarbons and reduces NOx. 9. Check for heat discoloration on the surface of the ATD. Heat discoloration may indicate internal damage; especially around the DPF. NOTE: Diesel exhaust fluid creeps, causing white crystals to form around the line fittings. The presence of crystals does not mean the system has a leak.
Replacing fittings or trouble- shooting components is not necessary unless there is a system failure or a fault code. Sensors—detect temperatures and pressures in the ATS. Inspection To meet EPA07 emissions regulations for vehicles domiciled in the USA or Canada, engines manufac- tured after December 31, 2006 are equipped with an emission aftertreatment system. Vehicles domiciled outside of the USA and Canada may not have after- treatment equipment, depending upon local statutory emissions guidelines. 10. Check the DEF tank, pump, metering unit, and lines for leaks. See Section 49.02 of the West- ern Star Workshop Manual for repair procedures. IMPORTANT:
The aftertreatment device (ATD), which is part of the aftertreatment system (ATS), requires special attention during regularly scheduled maintenance inspections; see Fig. 4 . No leaks are allowed anywhere in the system. If any discrepancies are discovered, refer to the 11. Check any wires, lines, or hoses within 4 inches (10 cm) of the exhaust system for heat damage. Repair or reroute as needed. Western Star Maintenance Manual, September 2015 49/2