Exhaust 49 12 13 14 9 9 1 2 3 8 10 11 7 6 4 08/20/2009 f490355 15 5 NOTE: The sensor box (item 8) contains the SCR inlet and outlet NOx sensors, DPF outlet pressure sensor, and the DOC inlet pressure sensor. 1. DOC Outlet Temperature Sensor 2. DOC Inlet Pressure Sensor Port 3. DOC Inlet Temperature Sensor 4. Front Heat Shield 5. DEF Nozzle 6. Exhaust Outlet 7. DEF Metering Unit 8. Sensor Box (see note above) 9. Exhaust Inlet 10. SCR Outlet Temperature Sensor 11. SCR Outlet NOx Sensor Port 12. SCR Inlet NOx Sensor Port 13. 14-Pin Connectors 14. DPF Outlet Pressure Sensor Port 15. SCR Inlet Temperature Sensor Fig.
1, One-Box ATS Sensor Locations engine manufacturer’s service literature for re- pair instructions. NOTICE 1. Check for leakage at the clamp that attaches the exhaust pipe to the turbocharger exhaust outlet. If leakage exists, tighten the nut on the clamp to the required torque. If leakage persists, install a new clamp. A leak in the CGI piping, including the bellows, will allow unfiltered air and contaminants into the engine intake, and can cause serious engine dam- age. NOTE: Because the CGI bellows is covered with a metal mesh, it is difficult to see cracks or damage that may cause a leak. 2.
Check the exhaust pipe, bellows, and each ex- haust seal clamp for leakage, wear, cracks, or damage. Replace damaged components as needed. If leakage exists at a clamp, tighten the nuts to the required torque. If leakage persists, install a new exhaust seal clamp. Do not reuse seal clamps. Once a seal clamp is loosened or removed, it must be replaced. 3. On vehicles with CAT engines, inspect the CGI bellows and piping for evidence of damage or leakage. See Fig. 5 . If the bellows is damaged or leaking, replace it. See 49–02 for the replace- ment procedure. 4. If present, check the condition of the insulation material around the exhaust pipe between the turbocharger and the ATD.
Western Star Maintenance Manual, September 2015 49/3