Daimler Trucks North America LLC Western Star — Western Star

Exhaust 49 1 2 10 11 3 8 9 4 10 9 8 7 6 5 09/16/2009 f490353 1. DEF Metering Unit 2. DEF Nozzle 3. SCR Outlet Temperature Sensor 4. SCR Inlet Temperature Sensor 5. DOC Inlet Temperature Sensor 6. DOC Inlet Pressure Sensor 7. DPF Inlet Temperature Sensor 8. DPF Outlet Pressure Sensor 9. DPF Outlet Temperature Sensor 10. DPF Outlet NOx Sensor 11. SCR Outlet NOx Sensor Fig. 2, 2V2 Two-Box ATS Sensor Locations 5. Check the ATD mounting bands for tightness. Tighten to 30 lbf·ft (41 N·m) if needed. Do not overtighten. 9. Check for heat discoloration on the surface of the ATD. Heat discoloration may indicate internal damage; especially around the DPF. 6.

Check for leaks around the clamps that attach the ATD in the ATS, and around the clamps that retain the DPF in the ATD. 10. Check any wires, lines, or hoses within 4 inches (10 cm) of the exhaust system for heat damage. Repair or reroute as needed. 7. Check all sensors attached to the ATD for leaks or damaged wires. No leaks are allowed. Pre-EPA07 Exhaust System Inspection 8. Check the DPF exterior surface for dents or other damage. See Item A of Fig. 4 . A dent over 3 inches (76 mm) in diameter and 1/4-inch (6- mm) deep could cause internal damage to the DPF, causing it to malfunction. 1. On all vehicles, check the condition of the muffler body and the top stack.

Check the inlet/outlet tubes for leakage, dents, and corrosion, and check for holes in the muffler. Replace parts as Western Star Maintenance Manual, September 2015 49/4