Exhaust 49 1 10 11 2 9 3 7 4 8 5 6 09/16/2009 f490354 1. DPF Inlet Temperature Sensor 2. DOC Inlet Temperature Sensor 3. DOC Inlet Pressure Sensor 4. DPF Sensor Box 5. DPF Outlet Pressure Sensor 6. DPF Outlet Temperature Sensor 7. DPF Outlet NOx Sensor 8. SCR Inlet Temperature Sensor 9. SCR Outlet Temperature Sensor 10. SCR Sensor Box 11. SCR Outlet NOx Sensor Fig. 3, 2HV Two-Box ATS Sensor Locations required. Use new parts, equivalent to parts originally installed on the vehicle. 7. Check the isolator at the base and the top of the exhaust stack (see Fig. 7 ) for cracking, damage, and dry rot. Replace as needed. 2. Inspect the exhaust flex hose (see Fig. 6 ) for leakage, wear, or damage.
Replace with new parts if replacement is needed. 8. Check for leakage at all wide-band exhaust clamps. See Fig. 8 . 3. Check for leakage at the V-band coupling, which attaches the exhaust pipe to the turbocharger exhaust outlet. See Fig. 6 . If leakage exists, tighten the nuts 40 to 60 lbf·ft (54 to 81 N·m). If leakage persists, inspect the wide-band exhaust clamps. Install a new Donald- son SealClamp if necessary. 4. If leakage exists, tighten the nut on the V-band coupling 85 lbf·in (940 N·cm). If leakage persists, install a new V-band coupling. 49–02 CAT CGI Bellows Replacement 5. Inspect the turbocharger outlet pipe, and replace it as needed. 6.
Check the U-bolt clamps for tightness, and tighten as needed. On vehicles with CAT EPA07 compliant engines, re- place the CGI bellows at the M4 maintenance inter- val to prevent a later failure. Western Star Maintenance Manual, September 2015 49/5