Exhaust 49 2 1 3 4 06/01/93 f490024a f490025a 05/28/93 1. Flex Hose 2. V-Band Coupling 3. Exhaust Pipe 4. Turbocharger Exhaust Outlet Fig. 8, Donaldson SealClamp Wide-Band Exhaust Clamp Fig. 6, V-Band Coupling and Flex Hose 3. Remove the right side inner fender/splash shield as needed. 4. Remove the CGI piping between the engine and aftertreatment device (ATD). See Fig. 9 . 5. On the workbench, remove the CGI bellows from the exhaust piping. Do not damage the piping. NOTE: The following step, and its substeps, is to be done without the bellows installed. This will align the pipes so that the bellows can be installed correctly. 1 2 6.
Install the CGI piping (without CGI bellows) and align piping. 6.1 Attach the aft CGI pipe to the ATD. 6.2 Attach the forward CGI pipe to the en- gine. 06/28/2001 f490241 1. Exhaust Elbow 2. Exhaust Isolator Fig. 7, Exhaust Isolator NOTICE NOTICE When the CGI pipes and bellows are installed, there should be approximately 3/4 inch (19 mm) clearance from the main bellows. Contact between the bellows could result in an exhaust leak, which in this case may allow ingestion of contaminants into the engine causing engine damage. A leak in the CGI piping, including the bellows, will allow unfiltered air and contaminants into the engine intake, and can cause serious engine damage. 1.
Park the vehicle, set the parking brake, chock the wheels. 6.3 Use a straightedge to align the pipes so that the pipe ends that attach to the bel- lows are parallel and concentric. 2. Open the hood. Western Star Maintenance Manual, September 2015 49/7