Heater and Air Conditioner 83 3. To access the air filters, remove the screws that attach the air filter cover to the air intake plenum. Remove the air filter cover. 4. Remove the two air filters from the air intake ple- num. See Fig. 3 . 5. Clean the air filters, as follows. 5.1 Wash the air filters by flushing soapy water from the air-outlet side of the filter to the air-intake side of the filter. 5.2 Rinse the air filters by flushing clear water from the air-outlet side of the filter to the air-intake side of the filter. 5.3 Allow the air filters to air dry. 6. Install the air filters in the air intake plenum. Make sure the arrow on the air filter is pointing in the direction shown in Fig. 3 . 1 7.
Using screws, attach the air filter cover to the HVAC assembly. 8. Attach the HVAC cover, if equipped, to the HVAC assembly. HVAC Pre-Filter Cleaning 09/09/2011 f831898 NOTE: On vehicles equipped with an HVAC pre-filter, the pre-filter is held in place by friction and a small clamping force; it has no fasteners. NOTE: On vehicles equipped with an HVAC pre- filter, the pre-filter should be cleaned every three months and replaced yearly. 1. Pre-Filter 1. Shut down the engine and set the parking brake. Chock the tires. Sleeper Fresh-Air Filter Replacement Fig. 4, HVAC Pre-Filter 2. Open the hood. 3. Remove the pre-filter mounted at the HVAC in- take. See Fig. 4 . 1.
Shut down the engine, set the parking brake, and chock the tires. 4. Clean the pre-filter, as follows. 4.1 Wash the pre-filter by flushing soapy water from the air-outlet side of the filter to the air-intake side of the filter. 2. To access the sleeper HVAC assembly, enter the sleeper and remove the bottom drawer from the left-side cabinet. 4.2 Rinse the pre-filter by flushing clear water from the air-outlet side of the filter to the air-intake side of the filter. 3. Remove the air filters from the sleeper HVAC assembly. See Fig. 5 . 4. Install new air filters in the sleeper HVAC assem- bly. Make sure the arrow on the air filter is point- ing toward the sleeper HVAC assembly; see Fig. 5 . 5.
Install the pre-filter, as removed. 4.3 Allow the pre-filter to air dry. 5. Install the drawer in the cabinet. Western Star Maintenance Manual, September 2015 83/3