Air Intake 09 Install a new cover gasket, making sure the seal- ing area around the studs is clean and free of any old gasket material. 5. If equipped with a dash-mounted restriction gauge, inspect the tube and mounting fittings on the air cleaner canister outlet pipe for tightness and correct routing of the line to the dash- mounted gauge. 8. Inspect the threaded area of the studs. They should be clean and free of corrosion and foreign material. Apply a light coating of oil. 6. If no restriction indicator of any kind is present, check that the plugs in the canister are torqued to specifications. Inspect the cap nuts. If wear is apparent replace them with new ones.
Torque the cap nuts in sequence 96 lbf·in (1080 N·cm). Do not over-tighten the cap nuts. Be cer- tain that the cover has pulled down evenly around the canister, because both element gas- kets and the cover gasket are being compressed as the cap nuts are tightened. 09–03 Charge Air Cooler Inspection 1. Check the condition of the charge air cooler pip- ing and clamping hardware. If damaged, replace components and carefully reassemble it to en- sure proper penetration and alignment. Tighten the constant-torque clamps 98 lbf·in (11 N·m), and the turbo-out-elbow clamp 62 lbf·in (7 N·m). See Fig. 14 . 9.
Recheck the torque of the canister band mount- ing clamps and be certain the blank portion of the top cap screen area is facing forward. 10. Press the reset button on the bottom of the air restriction indicator to reset to zero. If the indica- tor fails to reset to zero, replace it with a new one. If the truck is not equipped with a restriction indicator or a dash-mounted restriction gauge, check that the pipe plugs located in the canister, or in the aluminum piping just before the turbo- charger, are tight and correctly torqued. Frontwall-Mounted Air Cleaner, Non–4700 Models 2. Check the connections at the charge air cooler and all pipe-to-hose penetrations.
If acceptable, tighten the constant-torque clamps 98 lbf·in (11 N·m) and the turbo-out-elbow clamp 62 lbf·in (7 N·m). Angle the clamps downward to prevent interference with the hood. 3. Check the mounting and condition of the cooler core. 1. Release the spring clamp fasteners located at the left end of the air cleaner canister. See Fig. 4 , Ref. 4. Use caution when removing the element from the canister as some maneuvering may be necessary to avoid the radiator stay rod or brackets mounted in that area. 2. Inspect the interior of the canister. The under- hood air intake system has the air flow directed from the outside of the element to the inside.
Therefore, all dirt will be accumulated inside the canister housing, and it must be cleaned thor- oughly before reinstalling a replacement element. 3. Use caution when installing the new element to prevent damage to the paper pleats. Be certain the element is properly seated in the canister, then fasten the four spring clamp fasteners. 4. Inspect the air restriction indicator mounted at the outlet end pipe of the canister, and reset it. Western Star Maintenance Manual, January 2015 09/7