Air Intake 09 1 2 3 4 04/08/2005 f090431 5 Fig. 12, Manual-Reset Air Restriction Indicator, Go/ No-Go the element, outward through the filter element into the canister, then into the air intake piping on route to the turbocharger. It is highly recommended that only original equipment filter elements are used to service the air cleaner assemblies. Aftermarket re- placement elements may vary in size to the original equipment, or may use a different type of seal at the top and bottom of the element. A variance in the size of the element, or the thickness and type of seal ma- terial, can affect the crush of the gasket seal and could result in a poor seal on one of the mating sur- faces.
Elements that do not fit properly may allow the element to bounce in the canister and allow dirt to pass over the upper seal and into the canister and intake piping. 6 08/22/2001 f090417 1. Cap Nut 2. Service Cover 3. Service Cover Gasket 4. Filter Element 5. Mounting Band 6. Canister Fig. 13, Cowl-Mounted Air Cleaner If unable to remove all debris, use a vacuum cleaner to remove all remaining dirt, dust, and contamination. If the vehicle is equipped with dual air cleaners, re- place both elements at the same interval. 5. Clean the gasket sealing surfaces of the canister. Properly fitted gaskets are crucial to prevent dirt from entering the canister.
Use a damp cloth to wipe clean and remove any hard ridges of dirt built up around the old gasket sealing area on the top cover and the bottom of the canister. 1. Remove the cap nuts that secure the service cover to the canister. See Fig. 13 . Take note of the orientation of the air intake screen so the service cover can be reinstalled in the correct position. 2. After removing the canister cap, carefully pull the element straight up out of the canister, ensuring no dust or debris is dropped into the canister. 6. Apply pressure to the new gasket with your fin- gers to test for resilience. When you release pressure, the gasket should instantly spring back to its original shape. 3.
Inspect the clean side of the element and canis- ter for evidence of contamination. The clean side of the element is the area outside the gaskets on either end of the element, including the top cover. If debris is present, find the leak, deter- mine the cause, and correct the problem area immediately. 7. Slide in the new element, ensuring that the bot- tom gasket seats firmly. NOTE: The element will be sitting higher than normal until the cover bolts compress the gas- kets. 4. Clean the inside of the canister thoroughly. Use a clean damp cloth to wipe every surface clean. Western Star Maintenance Manual, January 2015 09/6