Engine Cooling/Radiator 20 Safety Precautions Keep the cooling system filled. On vehicles equipped with a frontwall-mounted translucent surge tank (see Fig. 1 ), keep the coolant level between the FULL and LOW marks. On vehicles equipped with a frontwall-mounted steel surge tank (see Fig. 2 ), keep the cooling system filled so that coolant can be seen in the sight glass in the surge tank. On vehicles equipped with a radiator-mounted translucent surge tank (see Fig. 3 ), keep the coolant level between the FULL and LOW marks. If the coolant is low, add the antifreeze solution mixture specified for the vehicle in PartsPro (Group 01).
DANGER When working on the vehicle, shut down the en- gine, set the parking brake, and chock the tires. Before working under the vehicle, always place jack stands under the frame rails to ensure the vehicle can not drop. Failure to follow these steps could result in serious personal injury or death. 20–01 Coolant Inspection General Information 2 The engine produces large quantities of heat during its operation. Too high or low an engine operating temperature will damage the engine. The purpose of the cooling system is to keep the engine at its opti- mum operating temperature.
The optimum operating temperature results in the most efficient use of fuel and allows the engine oil to do its job properly. 1 The cooling system on Western Star vehicles is a closed or pressure type system, with a mixture of antifreeze and water. By pressurizing the system and using an antifreeze/water mixture, the boiling tem- perature of the coolant is raised, permitting more effi- cient, higher operating temperatures. The coolant supplied with a Western Star vehicle is a 50/50 mix of antifreeze and water giving protection down to (–37°C). It is recommended that this be the minimum antifreeze mixture strength used.
The maximum coolant mixture of 60 percent anti- freeze to 40 percent water gives freeze protection to (–52°C). 09/07/2011 f200745 1. Surge Tank 2. Fill Cap Fig. 1, Frontwall-Mounted Translucent Surge Tank Inspection Over-concentration of antifreeze or coolant condi- tioner can cause silicate to settle out of the coolant, forming a silica-gel on cooling system inner surfaces, resulting in overheating. WARNING In addition, the tendency for silica-gel to form in- creases with water hardness. Hard water (with high levels of calcium and magnesium ions) increases likelihood of the formation of silica-gel. Do not use softened water. The salt used to artificially soften it is corrosive.
Most engine manufacturers prefer use of distilled or de-ionized water to reduce the potential and severity of silica dropouts. Do not remove or loosen the radiator cap until the engine and cooling system have completely cooled. Use extreme care when removing the cap. A sudden release of pressure from removing the cap prior to the system cooling can result in a surge of scalding coolant that could cause seri- ous personal injury. Western Star Maintenance Manual, September 2015 20/1